| # SPDX-License-Identifier: GPL-2.0-only |
| menu "Distributed Switch Architecture drivers" |
| depends on NET_DSA |
| |
| source "drivers/net/dsa/b53/Kconfig" |
| |
| config NET_DSA_BCM_SF2 |
| tristate "Broadcom Starfighter 2 Ethernet switch support" |
| depends on HAS_IOMEM |
| select NET_DSA_TAG_BRCM |
| select FIXED_PHY |
| select BCM7XXX_PHY |
| select MDIO_BCM_UNIMAC |
| select B53 |
| help |
| This enables support for the Broadcom Starfighter 2 Ethernet |
| switch chips. |
| |
| config NET_DSA_LOOP |
| tristate "DSA mock-up Ethernet switch chip support" |
| select NET_DSA_TAG_NONE |
| select FIXED_PHY |
| help |
| This enables support for a fake mock-up switch chip which |
| exercises the DSA APIs. |
| |
| source "drivers/net/dsa/hirschmann/Kconfig" |
| |
| config NET_DSA_LANTIQ_GSWIP |
| tristate "Lantiq / Intel GSWIP" |
| depends on HAS_IOMEM |
| select NET_DSA_TAG_GSWIP |
| help |
| This enables support for the Lantiq / Intel GSWIP 2.1 found in |
| the xrx200 / VR9 SoC. |
| |
| config NET_DSA_MT7530 |
| tristate "MediaTek MT7530 and MT7531 Ethernet switch support" |
| select NET_DSA_TAG_MTK |
| imply NET_DSA_MT7530_MDIO |
| imply NET_DSA_MT7530_MMIO |
| help |
| This enables support for the MediaTek MT7530 and MT7531 Ethernet |
| switch chips. Multi-chip module MT7530 in MT7621AT, MT7621DAT, |
| MT7621ST and MT7623AI SoCs, and built-in switch in MT7988 SoC are |
| supported as well. |
| |
| config NET_DSA_MT7530_MDIO |
| tristate "MediaTek MT7530 MDIO interface driver" |
| depends on NET_DSA_MT7530 |
| imply MEDIATEK_GE_PHY |
| select PCS_MTK_LYNXI |
| help |
| This enables support for the MediaTek MT7530 and MT7531 switch |
| chips which are connected via MDIO, as well as multi-chip |
| module MT7530 which can be found in the MT7621AT, MT7621DAT, |
| MT7621ST and MT7623AI SoCs. |
| |
| config NET_DSA_MT7530_MMIO |
| tristate "MediaTek MT7530 MMIO interface driver" |
| depends on NET_DSA_MT7530 |
| depends on HAS_IOMEM |
| imply MEDIATEK_GE_SOC_PHY |
| help |
| This enables support for the built-in Ethernet switch found |
| in the MediaTek MT7988 SoC. |
| The switch is a similar design as MT7531, but the switch registers |
| are directly mapped into the SoCs register space rather than being |
| accessible via MDIO. |
| |
| config NET_DSA_MV88E6060 |
| tristate "Marvell 88E6060 ethernet switch chip support" |
| select NET_DSA_TAG_TRAILER |
| help |
| This enables support for the Marvell 88E6060 ethernet switch |
| chip. |
| |
| source "drivers/net/dsa/microchip/Kconfig" |
| |
| source "drivers/net/dsa/mv88e6xxx/Kconfig" |
| |
| source "drivers/net/dsa/ocelot/Kconfig" |
| |
| source "drivers/net/dsa/qca/Kconfig" |
| |
| source "drivers/net/dsa/sja1105/Kconfig" |
| |
| source "drivers/net/dsa/xrs700x/Kconfig" |
| |
| source "drivers/net/dsa/realtek/Kconfig" |
| |
| config NET_DSA_RZN1_A5PSW |
| tristate "Renesas RZ/N1 A5PSW Ethernet switch support" |
| depends on OF && ARCH_RZN1 |
| select NET_DSA_TAG_RZN1_A5PSW |
| select PCS_RZN1_MIIC |
| help |
| This driver supports the A5PSW switch, which is embedded in Renesas |
| RZ/N1 SoC. |
| |
| config NET_DSA_SMSC_LAN9303 |
| tristate |
| select NET_DSA_TAG_LAN9303 |
| select REGMAP |
| help |
| This enables support for the Microchip LAN9303/LAN9354 3 port ethernet |
| switch chips. |
| |
| config NET_DSA_SMSC_LAN9303_I2C |
| tristate "SMSC/Microchip LAN9303 3-ports 10/100 ethernet switch in I2C managed mode" |
| depends on I2C |
| depends on VLAN_8021Q || VLAN_8021Q=n |
| select NET_DSA_SMSC_LAN9303 |
| select REGMAP_I2C |
| help |
| Enable access functions if the SMSC/Microchip LAN9303 is configured |
| for I2C managed mode. |
| |
| config NET_DSA_SMSC_LAN9303_MDIO |
| tristate "Microchip LAN9303/LAN9354 3-ports 10/100 ethernet switch in MDIO managed mode" |
| select NET_DSA_SMSC_LAN9303 |
| depends on VLAN_8021Q || VLAN_8021Q=n |
| help |
| Enable access functions if the Microchip LAN9303/LAN9354 is configured |
| for MDIO managed mode. |
| |
| config NET_DSA_VITESSE_VSC73XX |
| tristate |
| select NET_DSA_TAG_NONE |
| select FIXED_PHY |
| select VITESSE_PHY |
| select GPIOLIB |
| help |
| This enables support for the Vitesse VSC7385, VSC7388, |
| VSC7395 and VSC7398 SparX integrated ethernet switches. |
| |
| config NET_DSA_VITESSE_VSC73XX_SPI |
| tristate "Vitesse VSC7385/7388/7395/7398 SPI mode support" |
| depends on SPI |
| select NET_DSA_VITESSE_VSC73XX |
| help |
| This enables support for the Vitesse VSC7385, VSC7388, VSC7395 |
| and VSC7398 SparX integrated ethernet switches in SPI managed mode. |
| |
| config NET_DSA_VITESSE_VSC73XX_PLATFORM |
| tristate "Vitesse VSC7385/7388/7395/7398 Platform mode support" |
| depends on HAS_IOMEM |
| select NET_DSA_VITESSE_VSC73XX |
| help |
| This enables support for the Vitesse VSC7385, VSC7388, VSC7395 |
| and VSC7398 SparX integrated ethernet switches, connected over |
| a CPU-attached address bus and work in memory-mapped I/O mode. |
| endmenu |
