Documentation/devicetree/bindings/iio/magnetometer/yamaha,yas530.yaml

# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/iio/magnetometer/yamaha,yas530.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#

title: Yamaha YAS530 family of magnetometer sensors

maintainers:
  - Linus Walleij <linus.walleij@linaro.org>

description:
  The Yamaha YAS530 magnetometers is a line of 3-axis magnetometers
  first introduced by Yamaha in 2009 with the YAS530. They are successors
  of Yamaha's first magnetometer YAS529. Over the years this magnetometer
  has been miniaturized and appeared in a number of different variants.

properties:
  $nodename:
    pattern: '^magnetometer@[0-9a-f]+$'

  compatible:
    items:
      - enum:
          - yamaha,yas530
          - yamaha,yas532
          - yamaha,yas533
          - yamaha,yas535
          - yamaha,yas536
          - yamaha,yas537
          - yamaha,yas539

  reg:
    maxItems: 1

  reset-gpios:
    maxItems: 1
    description: The YAS530 sensor has a RSTN pin used to reset
      the logic inside the sensor. This GPIO line should connect
      to that pin and be marked as GPIO_ACTIVE_LOW.

  interrupts:
    maxItems: 1
    description: Interrupt for INT pin for interrupt generation.
      The polarity, whether the interrupt is active on the rising
      or the falling edge, is software-configurable in the hardware.

  vdd-supply:
    description: An optional regulator providing core power supply
      on the VDD pin, typically 1.8 V or 3.0 V.

  iovdd-supply:
    description: An optional regulator providing I/O power supply
      for the I2C interface on the IOVDD pin, typically 1.8 V.

  mount-matrix:
    description: An optional 3x3 mounting rotation matrix.

allOf:
  - if:
      not:
        properties:
          compatible:
            items:
              const: yamaha,yas530
    then:
      properties:
        reset-gpios: false

  - if:
      properties:
        compatible:
          items:
            const: yamaha,yas539
    then:
      properties:
        interrupts: false

required:
  - compatible
  - reg

additionalProperties: false

examples:
  - |
    #include <dt-bindings/interrupt-controller/irq.h>
    #include <dt-bindings/gpio/gpio.h>
    i2c-0 {
        #address-cells = <1>;
        #size-cells = <0>;

        magnetometer@2e {
          compatible = "yamaha,yas530";
          reg = <0x2e>;
          vdd-supply = <&ldo1_reg>;
          iovdd-supply = <&ldo2_reg>;
          reset-gpios = <&gpio6 12 GPIO_ACTIVE_LOW>;
          interrupts = <&gpio6 13 IRQ_TYPE_EDGE_RISING>;
        };
    };

    i2c-1 {
        #address-cells = <1>;
        #size-cells = <0>;

        magnetometer@2e {
          compatible = "yamaha,yas539";
          reg = <0x2e>;
          vdd-supply = <&ldo1_reg>;
        };
    };