| // SPDX-License-Identifier: MIT |
| /* |
| * Copyright © 2019 Intel Corporation |
| */ |
| |
| #include <linux/pci.h> |
| #include <linux/vgaarb.h> |
| |
| #include <drm/i915_drm.h> |
| |
| #include "i915_drv.h" |
| #include "intel_de.h" |
| #include "intel_vga.h" |
| |
| static i915_reg_t intel_vga_cntrl_reg(struct drm_i915_private *i915) |
| { |
| if (IS_VALLEYVIEW(i915) || IS_CHERRYVIEW(i915)) |
| return VLV_VGACNTRL; |
| else if (DISPLAY_VER(i915) >= 5) |
| return CPU_VGACNTRL; |
| else |
| return VGACNTRL; |
| } |
| |
| /* Disable the VGA plane that we never use */ |
| void intel_vga_disable(struct drm_i915_private *dev_priv) |
| { |
| struct pci_dev *pdev = to_pci_dev(dev_priv->drm.dev); |
| i915_reg_t vga_reg = intel_vga_cntrl_reg(dev_priv); |
| u8 sr1; |
| |
| if (intel_de_read(dev_priv, vga_reg) & VGA_DISP_DISABLE) |
| return; |
| |
| /* WaEnableVGAAccessThroughIOPort:ctg,elk,ilk,snb,ivb,vlv,hsw */ |
| vga_get_uninterruptible(pdev, VGA_RSRC_LEGACY_IO); |
| outb(SR01, VGA_SR_INDEX); |
| sr1 = inb(VGA_SR_DATA); |
| outb(sr1 | 1 << 5, VGA_SR_DATA); |
| vga_put(pdev, VGA_RSRC_LEGACY_IO); |
| udelay(300); |
| |
| intel_de_write(dev_priv, vga_reg, VGA_DISP_DISABLE); |
| intel_de_posting_read(dev_priv, vga_reg); |
| } |
| |
| void intel_vga_redisable_power_on(struct drm_i915_private *dev_priv) |
| { |
| i915_reg_t vga_reg = intel_vga_cntrl_reg(dev_priv); |
| |
| if (!(intel_de_read(dev_priv, vga_reg) & VGA_DISP_DISABLE)) { |
| drm_dbg_kms(&dev_priv->drm, |
| "Something enabled VGA plane, disabling it\n"); |
| intel_vga_disable(dev_priv); |
| } |
| } |
| |
| void intel_vga_redisable(struct drm_i915_private *i915) |
| { |
| intel_wakeref_t wakeref; |
| |
| /* |
| * This function can be called both from intel_modeset_setup_hw_state or |
| * at a very early point in our resume sequence, where the power well |
| * structures are not yet restored. Since this function is at a very |
| * paranoid "someone might have enabled VGA while we were not looking" |
| * level, just check if the power well is enabled instead of trying to |
| * follow the "don't touch the power well if we don't need it" policy |
| * the rest of the driver uses. |
| */ |
| wakeref = intel_display_power_get_if_enabled(i915, POWER_DOMAIN_VGA); |
| if (!wakeref) |
| return; |
| |
| intel_vga_redisable_power_on(i915); |
| |
| intel_display_power_put(i915, POWER_DOMAIN_VGA, wakeref); |
| } |
| |
| void intel_vga_reset_io_mem(struct drm_i915_private *i915) |
| { |
| struct pci_dev *pdev = to_pci_dev(i915->drm.dev); |
| |
| /* |
| * After we re-enable the power well, if we touch VGA register 0x3d5 |
| * we'll get unclaimed register interrupts. This stops after we write |
| * anything to the VGA MSR register. The vgacon module uses this |
| * register all the time, so if we unbind our driver and, as a |
| * consequence, bind vgacon, we'll get stuck in an infinite loop at |
| * console_unlock(). So make here we touch the VGA MSR register, making |
| * sure vgacon can keep working normally without triggering interrupts |
| * and error messages. |
| */ |
| vga_get_uninterruptible(pdev, VGA_RSRC_LEGACY_IO); |
| outb(inb(VGA_MSR_READ), VGA_MSR_WRITE); |
| vga_put(pdev, VGA_RSRC_LEGACY_IO); |
| } |
| |
| static int |
| intel_vga_set_state(struct drm_i915_private *i915, bool enable_decode) |
| { |
| unsigned int reg = DISPLAY_VER(i915) >= 6 ? SNB_GMCH_CTRL : INTEL_GMCH_CTRL; |
| u16 gmch_ctrl; |
| |
| if (pci_read_config_word(i915->bridge_dev, reg, &gmch_ctrl)) { |
| drm_err(&i915->drm, "failed to read control word\n"); |
| return -EIO; |
| } |
| |
| if (!!(gmch_ctrl & INTEL_GMCH_VGA_DISABLE) == !enable_decode) |
| return 0; |
| |
| if (enable_decode) |
| gmch_ctrl &= ~INTEL_GMCH_VGA_DISABLE; |
| else |
| gmch_ctrl |= INTEL_GMCH_VGA_DISABLE; |
| |
| if (pci_write_config_word(i915->bridge_dev, reg, gmch_ctrl)) { |
| drm_err(&i915->drm, "failed to write control word\n"); |
| return -EIO; |
| } |
| |
| return 0; |
| } |
| |
| static unsigned int |
| intel_vga_set_decode(struct pci_dev *pdev, bool enable_decode) |
| { |
| struct drm_i915_private *i915 = pdev_to_i915(pdev); |
| |
| intel_vga_set_state(i915, enable_decode); |
| |
| if (enable_decode) |
| return VGA_RSRC_LEGACY_IO | VGA_RSRC_LEGACY_MEM | |
| VGA_RSRC_NORMAL_IO | VGA_RSRC_NORMAL_MEM; |
| else |
| return VGA_RSRC_NORMAL_IO | VGA_RSRC_NORMAL_MEM; |
| } |
| |
| int intel_vga_register(struct drm_i915_private *i915) |
| { |
| |
| struct pci_dev *pdev = to_pci_dev(i915->drm.dev); |
| int ret; |
| |
| /* |
| * If we have > 1 VGA cards, then we need to arbitrate access to the |
| * common VGA resources. |
| * |
| * If we are a secondary display controller (!PCI_DISPLAY_CLASS_VGA), |
| * then we do not take part in VGA arbitration and the |
| * vga_client_register() fails with -ENODEV. |
| */ |
| ret = vga_client_register(pdev, intel_vga_set_decode); |
| if (ret && ret != -ENODEV) |
| return ret; |
| |
| return 0; |
| } |
| |
| void intel_vga_unregister(struct drm_i915_private *i915) |
| { |
| struct pci_dev *pdev = to_pci_dev(i915->drm.dev); |
| |
| vga_client_unregister(pdev); |
| } |