| # SPDX-License-Identifier: GPL-2.0 |
| |
| menuconfig ARCH_DAVINCI |
| bool "TI DaVinci" |
| depends on ARCH_MULTI_V5 |
| depends on CPU_LITTLE_ENDIAN |
| select CPU_ARM926T |
| select DAVINCI_TIMER |
| select ZONE_DMA |
| select PM_GENERIC_DOMAINS if PM |
| select PM_GENERIC_DOMAINS_OF if PM && OF |
| select REGMAP_MMIO |
| select RESET_CONTROLLER |
| select PINCTRL |
| select PINCTRL_SINGLE |
| |
| if ARCH_DAVINCI |
| |
| comment "DaVinci Core Type" |
| |
| config ARCH_DAVINCI_DA830 |
| bool "DA830/OMAP-L137/AM17x based system" |
| select ARCH_DAVINCI_DA8XX |
| # needed on silicon revs 1.0, 1.1: |
| select CPU_DCACHE_WRITETHROUGH if !CPU_DCACHE_DISABLE |
| select DAVINCI_CP_INTC |
| |
| config ARCH_DAVINCI_DA850 |
| bool "DA850/OMAP-L138/AM18x based system" |
| select DAVINCI_CP_INTC |
| |
| config ARCH_DAVINCI_DA8XX |
| bool |
| |
| config DAVINCI_MUX |
| bool "DAVINCI multiplexing support" |
| depends on ARCH_DAVINCI |
| default y |
| help |
| Pin multiplexing support for DAVINCI boards. If your bootloader |
| sets the multiplexing correctly, say N. Otherwise, or if unsure, |
| say Y. |
| |
| config DAVINCI_MUX_DEBUG |
| bool "Multiplexing debug output" |
| depends on DAVINCI_MUX |
| help |
| Makes the multiplexing functions print out a lot of debug info. |
| This is useful if you want to find out the correct values of the |
| multiplexing registers. |
| |
| config DAVINCI_MUX_WARNINGS |
| bool "Warn about pins the bootloader didn't set up" |
| depends on DAVINCI_MUX |
| help |
| Choose Y here to warn whenever driver initialization logic needs |
| to change the pin multiplexing setup. When there are no warnings |
| printed, it's safe to deselect DAVINCI_MUX for your product. |
| |
| endif |
