| PXA LCD Controller |
| ------------------ |
| |
| Required properties: |
| - compatible : one of these |
| "marvell,pxa2xx-lcdc", |
| "marvell,pxa270-lcdc", |
| "marvell,pxa300-lcdc" |
| - reg : should contain 1 register range (address and length). |
| - interrupts : framebuffer controller interrupt. |
| - clocks: phandle to input clocks |
| |
| Optional properties: |
| - lcd-supply: A phandle to a power regulator that controls the LCD voltage. |
| |
| Required nodes: |
| - port: connection to the LCD panel (see video-interfaces.txt) |
| This node must have its properties bus-width and remote-endpoint set. |
| If the panel is not a TFT color panel, then a "lcd-type" property in |
| the panel should specify the panel type. |
| This panel node should be in the board dts. |
| |
| Example: |
| lcd-controller@40500000 { |
| compatible = "marvell,pxa2xx-lcdc"; |
| reg = <0x44000000 0x10000>; |
| interrupts = <17>; |
| clocks = <&clks CLK_LCD>; |
| |
| port { |
| lcdc_out: endpoint { |
| remote-endpoint = <&panel_in>; |
| bus-width = <16>; |
| }; |
| }; |
| }; |
