| # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) |
| %YAML 1.2 |
| --- |
| $id: http://devicetree.org/schemas/iio/adc/atmel,sama5d2-adc.yaml# |
| $schema: http://devicetree.org/meta-schemas/core.yaml# |
| |
| title: AT91 SAMA5D2 Analog to Digital Converter (ADC) |
| |
| maintainers: |
| - Eugen Hristev <eugen.hristev@microchip.com> |
| |
| properties: |
| compatible: |
| enum: |
| - atmel,sama5d2-adc |
| - microchip,sam9x60-adc |
| - microchip,sama7g5-adc |
| |
| reg: |
| maxItems: 1 |
| |
| interrupts: |
| maxItems: 1 |
| |
| clocks: |
| maxItems: 1 |
| |
| clock-names: |
| const: adc_clk |
| |
| vref-supply: true |
| vddana-supply: true |
| |
| atmel,min-sample-rate-hz: |
| description: Minimum sampling rate, it depends on SoC. |
| |
| atmel,max-sample-rate-hz: |
| description: Maximum sampling rate, it depends on SoC. |
| |
| atmel,startup-time-ms: |
| description: Startup time expressed in ms, it depends on SoC. |
| |
| atmel,trigger-edge-type: |
| $ref: /schemas/types.yaml#/definitions/uint32 |
| description: |
| One of possible edge types for the ADTRG hardware trigger pin. |
| When the specific edge type is detected, the conversion will |
| start. Should be one of IRQ_TYPE_EDGE_RISING, IRQ_TYPE_EDGE_FALLING |
| or IRQ_TYPE_EDGE_BOTH. |
| enum: [1, 2, 3] |
| |
| dmas: |
| maxItems: 1 |
| |
| dma-names: |
| const: rx |
| |
| "#io-channel-cells": |
| const: 1 |
| |
| additionalProperties: false |
| |
| required: |
| - compatible |
| - reg |
| - interrupts |
| - clocks |
| - clock-names |
| - vref-supply |
| - vddana-supply |
| - atmel,min-sample-rate-hz |
| - atmel,max-sample-rate-hz |
| - atmel,startup-time-ms |
| |
| examples: |
| - | |
| #include <dt-bindings/dma/at91.h> |
| #include <dt-bindings/interrupt-controller/irq.h> |
| soc { |
| #address-cells = <1>; |
| #size-cells = <1>; |
| |
| adc@fc030000 { |
| compatible = "atmel,sama5d2-adc"; |
| reg = <0xfc030000 0x100>; |
| interrupts = <40 IRQ_TYPE_LEVEL_HIGH 7>; |
| clocks = <&adc_clk>; |
| clock-names = "adc_clk"; |
| atmel,min-sample-rate-hz = <200000>; |
| atmel,max-sample-rate-hz = <20000000>; |
| atmel,startup-time-ms = <4>; |
| vddana-supply = <&vdd_3v3_lp_reg>; |
| vref-supply = <&vdd_3v3_lp_reg>; |
| atmel,trigger-edge-type = <IRQ_TYPE_EDGE_BOTH>; |
| dmas = <&dma0 (AT91_XDMAC_DT_MEM_IF(0) | AT91_XDMAC_DT_PER_IF(1) | AT91_XDMAC_DT_PERID(25))>; |
| dma-names = "rx"; |
| #io-channel-cells = <1>; |
| }; |
| }; |
| ... |
