| # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) |
| %YAML 1.2 |
| --- |
| $id: http://devicetree.org/schemas/media/i2c/imx219.yaml# |
| $schema: http://devicetree.org/meta-schemas/core.yaml# |
| |
| title: Sony 1/4.0-Inch 8Mpixel CMOS Digital Image Sensor |
| |
| maintainers: |
| - Dave Stevenson <dave.stevenson@raspberrypi.com> |
| |
| description: |- |
| The Sony imx219 is a 1/4.0-inch CMOS active pixel digital image sensor |
| with an active array size of 3280H x 2464V. It is programmable through |
| I2C interface. The I2C address is fixed to 0x10 as per sensor data sheet. |
| Image data is sent through MIPI CSI-2, which is configured as either 2 or |
| 4 data lanes. |
| |
| properties: |
| compatible: |
| const: sony,imx219 |
| |
| reg: |
| description: I2C device address |
| maxItems: 1 |
| |
| clocks: |
| maxItems: 1 |
| |
| VDIG-supply: |
| description: |
| Digital I/O voltage supply, 1.8 volts |
| |
| VANA-supply: |
| description: |
| Analog voltage supply, 2.8 volts |
| |
| VDDL-supply: |
| description: |
| Digital core voltage supply, 1.2 volts |
| |
| reset-gpios: |
| maxItems: 1 |
| description: |- |
| Reference to the GPIO connected to the xclr pin, if any. |
| Must be released (set high) after all supplies are applied. |
| |
| port: |
| $ref: /schemas/graph.yaml#/$defs/port-base |
| additionalProperties: false |
| |
| properties: |
| endpoint: |
| $ref: /schemas/media/video-interfaces.yaml# |
| unevaluatedProperties: false |
| |
| properties: |
| data-lanes: |
| description: |- |
| The sensor supports either two-lane, or four-lane operation. |
| If this property is omitted four-lane operation is assumed. |
| For two-lane operation the property must be set to <1 2>. |
| items: |
| - const: 1 |
| - const: 2 |
| |
| clock-noncontinuous: true |
| link-frequencies: true |
| |
| required: |
| - link-frequencies |
| |
| required: |
| - compatible |
| - reg |
| - clocks |
| - VANA-supply |
| - VDIG-supply |
| - VDDL-supply |
| - port |
| |
| additionalProperties: false |
| |
| examples: |
| - | |
| i2c { |
| #address-cells = <1>; |
| #size-cells = <0>; |
| |
| imx219: sensor@10 { |
| compatible = "sony,imx219"; |
| reg = <0x10>; |
| clocks = <&imx219_clk>; |
| VANA-supply = <&imx219_vana>; /* 2.8v */ |
| VDIG-supply = <&imx219_vdig>; /* 1.8v */ |
| VDDL-supply = <&imx219_vddl>; /* 1.2v */ |
| |
| port { |
| imx219_0: endpoint { |
| remote-endpoint = <&csi1_ep>; |
| data-lanes = <1 2>; |
| clock-noncontinuous; |
| link-frequencies = /bits/ 64 <456000000>; |
| }; |
| }; |
| }; |
| }; |
| |
| ... |