| // SPDX-License-Identifier: GPL-2.0 |
| /* |
| * linux/arch/alpha/mm/init.c |
| * |
| * Copyright (C) 1995 Linus Torvalds |
| */ |
| |
| /* 2.3.x zone allocator, 1999 Andrea Arcangeli <andrea@suse.de> */ |
| |
| #include <linux/pagemap.h> |
| #include <linux/signal.h> |
| #include <linux/sched.h> |
| #include <linux/kernel.h> |
| #include <linux/errno.h> |
| #include <linux/string.h> |
| #include <linux/types.h> |
| #include <linux/ptrace.h> |
| #include <linux/mman.h> |
| #include <linux/mm.h> |
| #include <linux/swap.h> |
| #include <linux/init.h> |
| #include <linux/memblock.h> /* max_low_pfn */ |
| #include <linux/vmalloc.h> |
| #include <linux/gfp.h> |
| |
| #include <linux/uaccess.h> |
| #include <asm/pgtable.h> |
| #include <asm/pgalloc.h> |
| #include <asm/hwrpb.h> |
| #include <asm/dma.h> |
| #include <asm/mmu_context.h> |
| #include <asm/console.h> |
| #include <asm/tlb.h> |
| #include <asm/setup.h> |
| #include <asm/sections.h> |
| |
| extern void die_if_kernel(char *,struct pt_regs *,long); |
| |
| static struct pcb_struct original_pcb; |
| |
| pgd_t * |
| pgd_alloc(struct mm_struct *mm) |
| { |
| pgd_t *ret, *init; |
| |
| ret = (pgd_t *)__get_free_page(GFP_KERNEL | __GFP_ZERO); |
| init = pgd_offset(&init_mm, 0UL); |
| if (ret) { |
| #ifdef CONFIG_ALPHA_LARGE_VMALLOC |
| memcpy (ret + USER_PTRS_PER_PGD, init + USER_PTRS_PER_PGD, |
| (PTRS_PER_PGD - USER_PTRS_PER_PGD - 1)*sizeof(pgd_t)); |
| #else |
| pgd_val(ret[PTRS_PER_PGD-2]) = pgd_val(init[PTRS_PER_PGD-2]); |
| #endif |
| |
| /* The last PGD entry is the VPTB self-map. */ |
| pgd_val(ret[PTRS_PER_PGD-1]) |
| = pte_val(mk_pte(virt_to_page(ret), PAGE_KERNEL)); |
| } |
| return ret; |
| } |
| |
| |
| /* |
| * BAD_PAGE is the page that is used for page faults when linux |
| * is out-of-memory. Older versions of linux just did a |
| * do_exit(), but using this instead means there is less risk |
| * for a process dying in kernel mode, possibly leaving an inode |
| * unused etc.. |
| * |
| * BAD_PAGETABLE is the accompanying page-table: it is initialized |
| * to point to BAD_PAGE entries. |
| * |
| * ZERO_PAGE is a special page that is used for zero-initialized |
| * data and COW. |
| */ |
| pmd_t * |
| __bad_pagetable(void) |
| { |
| memset((void *) EMPTY_PGT, 0, PAGE_SIZE); |
| return (pmd_t *) EMPTY_PGT; |
| } |
| |
| pte_t |
| __bad_page(void) |
| { |
| memset((void *) EMPTY_PGE, 0, PAGE_SIZE); |
| return pte_mkdirty(mk_pte(virt_to_page(EMPTY_PGE), PAGE_SHARED)); |
| } |
| |
| static inline unsigned long |
| load_PCB(struct pcb_struct *pcb) |
| { |
| register unsigned long sp __asm__("$30"); |
| pcb->ksp = sp; |
| return __reload_thread(pcb); |
| } |
| |
| /* Set up initial PCB, VPTB, and other such nicities. */ |
| |
| static inline void |
| switch_to_system_map(void) |
| { |
| unsigned long newptbr; |
| unsigned long original_pcb_ptr; |
| |
| /* Initialize the kernel's page tables. Linux puts the vptb in |
| the last slot of the L1 page table. */ |
| memset(swapper_pg_dir, 0, PAGE_SIZE); |
| newptbr = ((unsigned long) swapper_pg_dir - PAGE_OFFSET) >> PAGE_SHIFT; |
| pgd_val(swapper_pg_dir[1023]) = |
| (newptbr << 32) | pgprot_val(PAGE_KERNEL); |
| |
| /* Set the vptb. This is often done by the bootloader, but |
| shouldn't be required. */ |
| if (hwrpb->vptb != 0xfffffffe00000000UL) { |
| wrvptptr(0xfffffffe00000000UL); |
| hwrpb->vptb = 0xfffffffe00000000UL; |
| hwrpb_update_checksum(hwrpb); |
| } |
| |
| /* Also set up the real kernel PCB while we're at it. */ |
| init_thread_info.pcb.ptbr = newptbr; |
| init_thread_info.pcb.flags = 1; /* set FEN, clear everything else */ |
| original_pcb_ptr = load_PCB(&init_thread_info.pcb); |
| tbia(); |
| |
| /* Save off the contents of the original PCB so that we can |
| restore the original console's page tables for a clean reboot. |
| |
| Note that the PCB is supposed to be a physical address, but |
| since KSEG values also happen to work, folks get confused. |
| Check this here. */ |
| |
| if (original_pcb_ptr < PAGE_OFFSET) { |
| original_pcb_ptr = (unsigned long) |
| phys_to_virt(original_pcb_ptr); |
| } |
| original_pcb = *(struct pcb_struct *) original_pcb_ptr; |
| } |
| |
| int callback_init_done; |
| |
| void * __init |
| callback_init(void * kernel_end) |
| { |
| struct crb_struct * crb; |
| pgd_t *pgd; |
| p4d_t *p4d; |
| pud_t *pud; |
| pmd_t *pmd; |
| void *two_pages; |
| |
| /* Starting at the HWRPB, locate the CRB. */ |
| crb = (struct crb_struct *)((char *)hwrpb + hwrpb->crb_offset); |
| |
| if (alpha_using_srm) { |
| /* Tell the console whither it is to be remapped. */ |
| if (srm_fixup(VMALLOC_START, (unsigned long)hwrpb)) |
| __halt(); /* "We're boned." --Bender */ |
| |
| /* Edit the procedure descriptors for DISPATCH and FIXUP. */ |
| crb->dispatch_va = (struct procdesc_struct *) |
| (VMALLOC_START + (unsigned long)crb->dispatch_va |
| - crb->map[0].va); |
| crb->fixup_va = (struct procdesc_struct *) |
| (VMALLOC_START + (unsigned long)crb->fixup_va |
| - crb->map[0].va); |
| } |
| |
| switch_to_system_map(); |
| |
| /* Allocate one PGD and one PMD. In the case of SRM, we'll need |
| these to actually remap the console. There is an assumption |
| here that only one of each is needed, and this allows for 8MB. |
| On systems with larger consoles, additional pages will be |
| allocated as needed during the mapping process. |
| |
| In the case of not SRM, but not CONFIG_ALPHA_LARGE_VMALLOC, |
| we need to allocate the PGD we use for vmalloc before we start |
| forking other tasks. */ |
| |
| two_pages = (void *) |
| (((unsigned long)kernel_end + ~PAGE_MASK) & PAGE_MASK); |
| kernel_end = two_pages + 2*PAGE_SIZE; |
| memset(two_pages, 0, 2*PAGE_SIZE); |
| |
| pgd = pgd_offset_k(VMALLOC_START); |
| p4d = p4d_offset(pgd, VMALLOC_START); |
| pud = pud_offset(p4d, VMALLOC_START); |
| pud_set(pud, (pmd_t *)two_pages); |
| pmd = pmd_offset(pud, VMALLOC_START); |
| pmd_set(pmd, (pte_t *)(two_pages + PAGE_SIZE)); |
| |
| if (alpha_using_srm) { |
| static struct vm_struct console_remap_vm; |
| unsigned long nr_pages = 0; |
| unsigned long vaddr; |
| unsigned long i, j; |
| |
| /* calculate needed size */ |
| for (i = 0; i < crb->map_entries; ++i) |
| nr_pages += crb->map[i].count; |
| |
| /* register the vm area */ |
| console_remap_vm.flags = VM_ALLOC; |
| console_remap_vm.size = nr_pages << PAGE_SHIFT; |
| vm_area_register_early(&console_remap_vm, PAGE_SIZE); |
| |
| vaddr = (unsigned long)console_remap_vm.addr; |
| |
| /* Set up the third level PTEs and update the virtual |
| addresses of the CRB entries. */ |
| for (i = 0; i < crb->map_entries; ++i) { |
| unsigned long pfn = crb->map[i].pa >> PAGE_SHIFT; |
| crb->map[i].va = vaddr; |
| for (j = 0; j < crb->map[i].count; ++j) { |
| /* Newer consoles (especially on larger |
| systems) may require more pages of |
| PTEs. Grab additional pages as needed. */ |
| if (pmd != pmd_offset(pud, vaddr)) { |
| memset(kernel_end, 0, PAGE_SIZE); |
| pmd = pmd_offset(pud, vaddr); |
| pmd_set(pmd, (pte_t *)kernel_end); |
| kernel_end += PAGE_SIZE; |
| } |
| set_pte(pte_offset_kernel(pmd, vaddr), |
| pfn_pte(pfn, PAGE_KERNEL)); |
| pfn++; |
| vaddr += PAGE_SIZE; |
| } |
| } |
| } |
| |
| callback_init_done = 1; |
| return kernel_end; |
| } |
| |
| |
| #ifndef CONFIG_DISCONTIGMEM |
| /* |
| * paging_init() sets up the memory map. |
| */ |
| void __init paging_init(void) |
| { |
| unsigned long max_zone_pfn[MAX_NR_ZONES] = {0, }; |
| unsigned long dma_pfn; |
| |
| dma_pfn = virt_to_phys((char *)MAX_DMA_ADDRESS) >> PAGE_SHIFT; |
| max_pfn = max_low_pfn; |
| |
| max_zone_pfn[ZONE_DMA] = dma_pfn; |
| max_zone_pfn[ZONE_NORMAL] = max_pfn; |
| |
| /* Initialize mem_map[]. */ |
| free_area_init(max_zone_pfn); |
| |
| /* Initialize the kernel's ZERO_PGE. */ |
| memset((void *)ZERO_PGE, 0, PAGE_SIZE); |
| } |
| #endif /* CONFIG_DISCONTIGMEM */ |
| |
| #if defined(CONFIG_ALPHA_GENERIC) || defined(CONFIG_ALPHA_SRM) |
| void |
| srm_paging_stop (void) |
| { |
| /* Move the vptb back to where the SRM console expects it. */ |
| swapper_pg_dir[1] = swapper_pg_dir[1023]; |
| tbia(); |
| wrvptptr(0x200000000UL); |
| hwrpb->vptb = 0x200000000UL; |
| hwrpb_update_checksum(hwrpb); |
| |
| /* Reload the page tables that the console had in use. */ |
| load_PCB(&original_pcb); |
| tbia(); |
| } |
| #endif |
| |
| void __init |
| mem_init(void) |
| { |
| set_max_mapnr(max_low_pfn); |
| high_memory = (void *) __va(max_low_pfn * PAGE_SIZE); |
| memblock_free_all(); |
| mem_init_print_info(NULL); |
| } |