| // SPDX-License-Identifier: GPL-2.0-only | |
| /* | |
| * Helper module for board specific I2C bus registration | |
| * | |
| * Copyright (C) 2009 Nokia Corporation. | |
| */ | |
| #include "soc.h" | |
| #include "omap_hwmod.h" | |
| #include "omap_device.h" | |
| #include "prm.h" | |
| #include "common.h" | |
| #include "i2c.h" | |
| /* In register I2C_CON, Bit 15 is the I2C enable bit */ | |
| #define I2C_EN BIT(15) | |
| #define OMAP2_I2C_CON_OFFSET 0x24 | |
| #define OMAP4_I2C_CON_OFFSET 0xA4 | |
| #define MAX_OMAP_I2C_HWMOD_NAME_LEN 16 | |
| /** | |
| * omap_i2c_reset - reset the omap i2c module. | |
| * @oh: struct omap_hwmod * | |
| * | |
| * The i2c moudle in omap2, omap3 had a special sequence to reset. The | |
| * sequence is: | |
| * - Disable the I2C. | |
| * - Write to SOFTRESET bit. | |
| * - Enable the I2C. | |
| * - Poll on the RESETDONE bit. | |
| * The sequence is implemented in below function. This is called for 2420, | |
| * 2430 and omap3. | |
| */ | |
| int omap_i2c_reset(struct omap_hwmod *oh) | |
| { | |
| u32 v; | |
| u16 i2c_con; | |
| int c = 0; | |
| if (soc_is_omap24xx() || soc_is_omap34xx() || soc_is_am35xx()) | |
| i2c_con = OMAP2_I2C_CON_OFFSET; | |
| else | |
| i2c_con = OMAP4_I2C_CON_OFFSET; | |
| /* Disable I2C */ | |
| v = omap_hwmod_read(oh, i2c_con); | |
| v &= ~I2C_EN; | |
| omap_hwmod_write(v, oh, i2c_con); | |
| /* Write to the SOFTRESET bit */ | |
| omap_hwmod_softreset(oh); | |
| /* Enable I2C */ | |
| v = omap_hwmod_read(oh, i2c_con); | |
| v |= I2C_EN; | |
| omap_hwmod_write(v, oh, i2c_con); | |
| /* Poll on RESETDONE bit */ | |
| omap_test_timeout((omap_hwmod_read(oh, | |
| oh->class->sysc->syss_offs) | |
| & SYSS_RESETDONE_MASK), | |
| MAX_MODULE_SOFTRESET_WAIT, c); | |
| if (c == MAX_MODULE_SOFTRESET_WAIT) | |
| pr_warn("%s: %s: softreset failed (waited %d usec)\n", | |
| __func__, oh->name, MAX_MODULE_SOFTRESET_WAIT); | |
| else | |
| pr_debug("%s: %s: softreset in %d usec\n", __func__, | |
| oh->name, c); | |
| return 0; | |
| } |