| /* SPDX-License-Identifier: GPL-2.0 */ | |
| #include <linux/platform_data/usb-omap.h> | |
| /* AM35x */ | |
| /* USB 2.0 PHY Control */ | |
| #define CONF2_PHY_GPIOMODE (1 << 23) | |
| #define CONF2_OTGMODE (3 << 14) | |
| #define CONF2_NO_OVERRIDE (0 << 14) | |
| #define CONF2_FORCE_HOST (1 << 14) | |
| #define CONF2_FORCE_DEVICE (2 << 14) | |
| #define CONF2_FORCE_HOST_VBUS_LOW (3 << 14) | |
| #define CONF2_SESENDEN (1 << 13) | |
| #define CONF2_VBDTCTEN (1 << 12) | |
| #define CONF2_REFFREQ_24MHZ (2 << 8) | |
| #define CONF2_REFFREQ_26MHZ (7 << 8) | |
| #define CONF2_REFFREQ_13MHZ (6 << 8) | |
| #define CONF2_REFFREQ (0xf << 8) | |
| #define CONF2_PHYCLKGD (1 << 7) | |
| #define CONF2_VBUSSENSE (1 << 6) | |
| #define CONF2_PHY_PLLON (1 << 5) | |
| #define CONF2_RESET (1 << 4) | |
| #define CONF2_PHYPWRDN (1 << 3) | |
| #define CONF2_OTGPWRDN (1 << 2) | |
| #define CONF2_DATPOL (1 << 1) | |
| /* TI81XX specific definitions */ | |
| #define USBCTRL0 0x620 | |
| #define USBSTAT0 0x624 | |
| /* TI816X PHY controls bits */ | |
| #define TI816X_USBPHY0_NORMAL_MODE (1 << 0) | |
| #define TI816X_USBPHY_REFCLK_OSC (1 << 8) | |
| /* TI814X PHY controls bits */ | |
| #define USBPHY_CM_PWRDN (1 << 0) | |
| #define USBPHY_OTG_PWRDN (1 << 1) | |
| #define USBPHY_CHGDET_DIS (1 << 2) | |
| #define USBPHY_CHGDET_RSTRT (1 << 3) | |
| #define USBPHY_SRCONDM (1 << 4) | |
| #define USBPHY_SINKONDP (1 << 5) | |
| #define USBPHY_CHGISINK_EN (1 << 6) | |
| #define USBPHY_CHGVSRC_EN (1 << 7) | |
| #define USBPHY_DMPULLUP (1 << 8) | |
| #define USBPHY_DPPULLUP (1 << 9) | |
| #define USBPHY_CDET_EXTCTL (1 << 10) | |
| #define USBPHY_GPIO_MODE (1 << 12) | |
| #define USBPHY_DPOPBUFCTL (1 << 13) | |
| #define USBPHY_DMOPBUFCTL (1 << 14) | |
| #define USBPHY_DPINPUT (1 << 15) | |
| #define USBPHY_DMINPUT (1 << 16) | |
| #define USBPHY_DPGPIO_PD (1 << 17) | |
| #define USBPHY_DMGPIO_PD (1 << 18) | |
| #define USBPHY_OTGVDET_EN (1 << 19) | |
| #define USBPHY_OTGSESSEND_EN (1 << 20) | |
| #define USBPHY_DATA_POLARITY (1 << 23) | |
| struct usbhs_phy_data { | |
| int port; /* 1 indexed port number */ | |
| int reset_gpio; | |
| int vcc_gpio; | |
| bool vcc_polarity; /* 1 active high, 0 active low */ | |
| }; | |
| extern void usb_musb_init(struct omap_musb_board_data *board_data); | |
| extern void usbhs_init(struct usbhs_omap_platform_data *pdata); | |
| extern int usbhs_init_phys(struct usbhs_phy_data *phy, int num_phys); | |
| extern void am35x_musb_reset(void); | |
| extern void am35x_musb_phy_power(u8 on); | |
| extern void am35x_musb_clear_irq(void); | |
| extern void am35x_set_mode(u8 musb_mode); |