| # SPDX-License-Identifier: GPL-2.0 |
| # |
| # Bus Devices |
| # |
| |
| menu "Bus devices" |
| |
| config ARM_CCI |
| bool |
| |
| config ARM_CCI400_COMMON |
| bool |
| select ARM_CCI |
| |
| config ARM_CCI400_PORT_CTRL |
| bool |
| depends on ARM && OF && CPU_V7 |
| select ARM_CCI400_COMMON |
| help |
| Low level power management driver for CCI400 cache coherent |
| interconnect for ARM platforms. |
| |
| config ARM_INTEGRATOR_LM |
| bool "ARM Integrator Logic Module bus" |
| depends on HAS_IOMEM |
| depends on ARCH_INTEGRATOR || COMPILE_TEST |
| default ARCH_INTEGRATOR |
| help |
| Say y here to enable support for the ARM Logic Module bus |
| found on the ARM Integrator AP (Application Platform) |
| |
| config BRCMSTB_GISB_ARB |
| bool "Broadcom STB GISB bus arbiter" |
| depends on ARM || ARM64 || MIPS |
| default ARCH_BRCMSTB || BMIPS_GENERIC |
| help |
| Driver for the Broadcom Set Top Box System-on-a-chip internal bus |
| arbiter. This driver provides timeout and target abort error handling |
| and internal bus master decoding. |
| |
| config BT1_APB |
| bool "Baikal-T1 APB-bus driver" |
| depends on MIPS_BAIKAL_T1 || COMPILE_TEST |
| select REGMAP_MMIO |
| help |
| Baikal-T1 AXI-APB bridge is used to access the SoC subsystem CSRs. |
| IO requests are routed to this bus by means of the DW AMBA 3 AXI |
| Interconnect. In case of any APB protocol collisions, slave device |
| not responding on timeout an IRQ is raised with an erroneous address |
| reported to the APB terminator (APB Errors Handler Block). This |
| driver provides the interrupt handler to detect the erroneous |
| address, prints an error message about the address fault, updates an |
| errors counter. The counter and the APB-bus operations timeout can be |
| accessed via corresponding sysfs nodes. |
| |
| config BT1_AXI |
| bool "Baikal-T1 AXI-bus driver" |
| depends on MIPS_BAIKAL_T1 || COMPILE_TEST |
| select MFD_SYSCON |
| help |
| AXI3-bus is the main communication bus connecting all high-speed |
| peripheral IP-cores with RAM controller and with MIPS P5600 cores on |
| Baikal-T1 SoC. Traffic arbitration is done by means of DW AMBA 3 AXI |
| Interconnect (so called AXI Main Interconnect) routing IO requests |
| from one SoC block to another. This driver provides a way to detect |
| any bus protocol errors and device not responding situations by |
| means of an embedded on top of the interconnect errors handler |
| block (EHB). AXI Interconnect QoS arbitration tuning is currently |
| unsupported. |
| |
| config MOXTET |
| tristate "CZ.NIC Turris Mox module configuration bus" |
| depends on SPI_MASTER && OF |
| help |
| Say yes here to add support for the module configuration bus found |
| on CZ.NIC's Turris Mox. This is needed for the ability to discover |
| the order in which the modules are connected and to get/set some of |
| their settings. For example the GPIOs on Mox SFP module are |
| configured through this bus. |
| |
| config HISILICON_LPC |
| bool "Support for ISA I/O space on HiSilicon Hip06/7" |
| depends on (ARM64 && ARCH_HISI) || (COMPILE_TEST && !ALPHA && !HEXAGON && !PARISC && !C6X) |
| depends on HAS_IOMEM |
| select INDIRECT_PIO if ARM64 |
| help |
| Driver to enable I/O access to devices attached to the Low Pin |
| Count bus on the HiSilicon Hip06/7 SoC. |
| |
| config IMX_WEIM |
| bool "Freescale EIM DRIVER" |
| depends on ARCH_MXC |
| help |
| Driver for i.MX WEIM controller. |
| The WEIM(Wireless External Interface Module) works like a bus. |
| You can attach many different devices on it, such as NOR, onenand. |
| |
| config MIPS_CDMM |
| bool "MIPS Common Device Memory Map (CDMM) Driver" |
| depends on CPU_MIPSR2 || CPU_MIPSR5 |
| help |
| Driver needed for the MIPS Common Device Memory Map bus in MIPS |
| cores. This bus is for per-CPU tightly coupled devices such as the |
| Fast Debug Channel (FDC). |
| |
| For this to work, either your bootloader needs to enable the CDMM |
| region at an unused physical address on the boot CPU, or else your |
| platform code needs to implement mips_cdmm_phys_base() (see |
| asm/cdmm.h). |
| |
| config MVEBU_MBUS |
| bool |
| depends on PLAT_ORION |
| help |
| Driver needed for the MBus configuration on Marvell EBU SoCs |
| (Kirkwood, Dove, Orion5x, MV78XX0 and Armada 370/XP). |
| |
| config OMAP_INTERCONNECT |
| tristate "OMAP INTERCONNECT DRIVER" |
| depends on ARCH_OMAP2PLUS |
| |
| help |
| Driver to enable OMAP interconnect error handling driver. |
| |
| config OMAP_OCP2SCP |
| tristate "OMAP OCP2SCP DRIVER" |
| depends on ARCH_OMAP2PLUS |
| help |
| Driver to enable ocp2scp module which transforms ocp interface |
| protocol to scp protocol. In OMAP4, USB PHY is connected via |
| OCP2SCP and in OMAP5, both USB PHY and SATA PHY is connected via |
| OCP2SCP. |
| |
| config QCOM_EBI2 |
| bool "Qualcomm External Bus Interface 2 (EBI2)" |
| depends on HAS_IOMEM |
| depends on ARCH_QCOM || COMPILE_TEST |
| default ARCH_QCOM |
| help |
| Say y here to enable support for the Qualcomm External Bus |
| Interface 2, which can be used to connect things like NAND Flash, |
| SRAM, ethernet adapters, FPGAs and LCD displays. |
| |
| config SIMPLE_PM_BUS |
| tristate "Simple Power-Managed Bus Driver" |
| depends on OF && PM |
| help |
| Driver for transparent busses that don't need a real driver, but |
| where the bus controller is part of a PM domain, or under the control |
| of a functional clock, and thus relies on runtime PM for managing |
| this PM domain and/or clock. |
| An example of such a bus controller is the Renesas Bus State |
| Controller (BSC, sometimes called "LBSC within Bus Bridge", or |
| "External Bus Interface") as found on several Renesas ARM SoCs. |
| |
| config SUN50I_DE2_BUS |
| bool "Allwinner A64 DE2 Bus Driver" |
| default ARM64 |
| depends on ARCH_SUNXI |
| select SUNXI_SRAM |
| help |
| Say y here to enable support for Allwinner A64 DE2 bus driver. It's |
| mostly transparent, but a SRAM region needs to be claimed in the SRAM |
| controller to make the all blocks in the DE2 part accessible. |
| |
| config SUNXI_RSB |
| tristate "Allwinner sunXi Reduced Serial Bus Driver" |
| default MACH_SUN8I || MACH_SUN9I || ARM64 |
| depends on ARCH_SUNXI |
| select REGMAP |
| help |
| Say y here to enable support for Allwinner's Reduced Serial Bus |
| (RSB) support. This controller is responsible for communicating |
| with various RSB based devices, such as AXP223, AXP8XX PMICs, |
| and AC100/AC200 ICs. |
| |
| config TEGRA_ACONNECT |
| tristate "Tegra ACONNECT Bus Driver" |
| depends on ARCH_TEGRA_210_SOC |
| depends on OF && PM |
| help |
| Driver for the Tegra ACONNECT bus which is used to interface with |
| the devices inside the Audio Processing Engine (APE) for Tegra210. |
| |
| config TEGRA_GMI |
| tristate "Tegra Generic Memory Interface bus driver" |
| depends on ARCH_TEGRA |
| help |
| Driver for the Tegra Generic Memory Interface bus which can be used |
| to attach devices such as NOR, UART, FPGA and more. |
| |
| config TI_PWMSS |
| bool |
| default y if (ARCH_OMAP2PLUS) && (PWM_TIECAP || PWM_TIEHRPWM || TI_EQEP) |
| help |
| PWM Subsystem driver support for AM33xx SOC. |
| |
| PWM submodules require PWM config space access from submodule |
| drivers and require common parent driver support. |
| |
| config TI_SYSC |
| bool "TI sysc interconnect target module driver" |
| depends on ARCH_OMAP2PLUS |
| help |
| Generic driver for Texas Instruments interconnect target module |
| found on many TI SoCs. |
| |
| config TS_NBUS |
| tristate "Technologic Systems NBUS Driver" |
| depends on SOC_IMX28 |
| depends on OF_GPIO && PWM |
| help |
| Driver for the Technologic Systems NBUS which is used to interface |
| with the peripherals in the FPGA of the TS-4600 SoM. |
| |
| config UNIPHIER_SYSTEM_BUS |
| tristate "UniPhier System Bus driver" |
| depends on ARCH_UNIPHIER && OF |
| default y |
| help |
| Support for UniPhier System Bus, a simple external bus. This is |
| needed to use on-board devices connected to UniPhier SoCs. |
| |
| config VEXPRESS_CONFIG |
| tristate "Versatile Express configuration bus" |
| default y if ARCH_VEXPRESS |
| depends on ARM || ARM64 |
| depends on OF |
| select REGMAP |
| help |
| Platform configuration infrastructure for the ARM Ltd. |
| Versatile Express. |
| |
| config DA8XX_MSTPRI |
| bool "TI da8xx master peripheral priority driver" |
| depends on ARCH_DAVINCI_DA8XX |
| help |
| Driver for Texas Instruments da8xx master peripheral priority |
| configuration. Allows to adjust the priorities of all master |
| peripherals. |
| |
| source "drivers/bus/fsl-mc/Kconfig" |
| source "drivers/bus/mhi/Kconfig" |
| |
| endmenu |
