blob: 4dc412437b086d6470038f60480b7af03ddf7e3d [file] [log] [blame] [edit]
Lattice iCE40 FPGA Manager
Required properties:
- compatible: Should contain "lattice,ice40-fpga-mgr"
- reg: SPI chip select
- spi-max-frequency: Maximum SPI frequency (>=1000000, <=25000000)
- cdone-gpios: GPIO input connected to CDONE pin
- reset-gpios: Active-low GPIO output connected to CRESET_B pin. Note
that unless the GPIO is held low during startup, the
FPGA will enter Master SPI mode and drive SCK with a
clock signal potentially jamming other devices on the
bus until the firmware is loaded.
Example:
fpga: fpga@0 {
compatible = "lattice,ice40-fpga-mgr";
reg = <0>;
spi-max-frequency = <1000000>;
cdone-gpios = <&gpio 24 GPIO_ACTIVE_HIGH>;
reset-gpios = <&gpio 22 GPIO_ACTIVE_LOW>;
};