| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Azoteq IQS620A PWM Generator |
| * |
| * Copyright (C) 2019 Jeff LaBundy <jeff@labundy.com> |
| * |
| * Limitations: |
| * - The period is fixed to 1 ms and is generated continuously despite changes |
| * to the duty cycle or enable/disable state. |
| * - Changes to the duty cycle or enable/disable state take effect immediately |
| * and may result in a glitch during the period in which the change is made. |
| * - The device cannot generate a 0% duty cycle. For duty cycles below 1 / 256 |
| * ms, the output is disabled and relies upon an external pull-down resistor |
| * to hold the GPIO3/LTX pin low. |
| */ |
| |
| #include <linux/device.h> |
| #include <linux/kernel.h> |
| #include <linux/mfd/iqs62x.h> |
| #include <linux/module.h> |
| #include <linux/mutex.h> |
| #include <linux/notifier.h> |
| #include <linux/platform_device.h> |
| #include <linux/pwm.h> |
| #include <linux/regmap.h> |
| #include <linux/slab.h> |
| |
| #define IQS620_PWR_SETTINGS 0xd2 |
| #define IQS620_PWR_SETTINGS_PWM_OUT BIT(7) |
| |
| #define IQS620_PWM_DUTY_CYCLE 0xd8 |
| |
| #define IQS620_PWM_PERIOD_NS 1000000 |
| |
| struct iqs620_pwm_private { |
| struct iqs62x_core *iqs62x; |
| struct pwm_chip chip; |
| struct notifier_block notifier; |
| struct mutex lock; |
| bool out_en; |
| u8 duty_val; |
| }; |
| |
| static int iqs620_pwm_apply(struct pwm_chip *chip, struct pwm_device *pwm, |
| const struct pwm_state *state) |
| { |
| struct iqs620_pwm_private *iqs620_pwm; |
| struct iqs62x_core *iqs62x; |
| u64 duty_scale; |
| int ret; |
| |
| if (state->polarity != PWM_POLARITY_NORMAL) |
| return -ENOTSUPP; |
| |
| if (state->period < IQS620_PWM_PERIOD_NS) |
| return -EINVAL; |
| |
| iqs620_pwm = container_of(chip, struct iqs620_pwm_private, chip); |
| iqs62x = iqs620_pwm->iqs62x; |
| |
| /* |
| * The duty cycle generated by the device is calculated as follows: |
| * |
| * duty_cycle = (IQS620_PWM_DUTY_CYCLE + 1) / 256 * 1 ms |
| * |
| * ...where IQS620_PWM_DUTY_CYCLE is a register value between 0 and 255 |
| * (inclusive). Therefore the lowest duty cycle the device can generate |
| * while the output is enabled is 1 / 256 ms. |
| * |
| * For lower duty cycles (e.g. 0), the PWM output is simply disabled to |
| * allow an external pull-down resistor to hold the GPIO3/LTX pin low. |
| */ |
| duty_scale = div_u64(state->duty_cycle * 256, IQS620_PWM_PERIOD_NS); |
| |
| mutex_lock(&iqs620_pwm->lock); |
| |
| if (!state->enabled || !duty_scale) { |
| ret = regmap_update_bits(iqs62x->regmap, IQS620_PWR_SETTINGS, |
| IQS620_PWR_SETTINGS_PWM_OUT, 0); |
| if (ret) |
| goto err_mutex; |
| } |
| |
| if (duty_scale) { |
| u8 duty_val = min_t(u64, duty_scale - 1, 0xff); |
| |
| ret = regmap_write(iqs62x->regmap, IQS620_PWM_DUTY_CYCLE, |
| duty_val); |
| if (ret) |
| goto err_mutex; |
| |
| iqs620_pwm->duty_val = duty_val; |
| } |
| |
| if (state->enabled && duty_scale) { |
| ret = regmap_update_bits(iqs62x->regmap, IQS620_PWR_SETTINGS, |
| IQS620_PWR_SETTINGS_PWM_OUT, 0xff); |
| if (ret) |
| goto err_mutex; |
| } |
| |
| iqs620_pwm->out_en = state->enabled; |
| |
| err_mutex: |
| mutex_unlock(&iqs620_pwm->lock); |
| |
| return ret; |
| } |
| |
| static void iqs620_pwm_get_state(struct pwm_chip *chip, struct pwm_device *pwm, |
| struct pwm_state *state) |
| { |
| struct iqs620_pwm_private *iqs620_pwm; |
| |
| iqs620_pwm = container_of(chip, struct iqs620_pwm_private, chip); |
| |
| mutex_lock(&iqs620_pwm->lock); |
| |
| /* |
| * Since the device cannot generate a 0% duty cycle, requests to do so |
| * cause subsequent calls to iqs620_pwm_get_state to report the output |
| * as disabled with duty cycle equal to that which was in use prior to |
| * the request. This is not ideal, but is the best compromise based on |
| * the capabilities of the device. |
| */ |
| state->enabled = iqs620_pwm->out_en; |
| state->duty_cycle = DIV_ROUND_UP((iqs620_pwm->duty_val + 1) * |
| IQS620_PWM_PERIOD_NS, 256); |
| |
| mutex_unlock(&iqs620_pwm->lock); |
| |
| state->period = IQS620_PWM_PERIOD_NS; |
| } |
| |
| static int iqs620_pwm_notifier(struct notifier_block *notifier, |
| unsigned long event_flags, void *context) |
| { |
| struct iqs620_pwm_private *iqs620_pwm; |
| struct iqs62x_core *iqs62x; |
| int ret; |
| |
| if (!(event_flags & BIT(IQS62X_EVENT_SYS_RESET))) |
| return NOTIFY_DONE; |
| |
| iqs620_pwm = container_of(notifier, struct iqs620_pwm_private, |
| notifier); |
| iqs62x = iqs620_pwm->iqs62x; |
| |
| mutex_lock(&iqs620_pwm->lock); |
| |
| /* |
| * The parent MFD driver already prints an error message in the event |
| * of a device reset, so nothing else is printed here unless there is |
| * an additional failure. |
| */ |
| ret = regmap_write(iqs62x->regmap, IQS620_PWM_DUTY_CYCLE, |
| iqs620_pwm->duty_val); |
| if (ret) |
| goto err_mutex; |
| |
| ret = regmap_update_bits(iqs62x->regmap, IQS620_PWR_SETTINGS, |
| IQS620_PWR_SETTINGS_PWM_OUT, |
| iqs620_pwm->out_en ? 0xff : 0); |
| |
| err_mutex: |
| mutex_unlock(&iqs620_pwm->lock); |
| |
| if (ret) { |
| dev_err(iqs620_pwm->chip.dev, |
| "Failed to re-initialize device: %d\n", ret); |
| return NOTIFY_BAD; |
| } |
| |
| return NOTIFY_OK; |
| } |
| |
| static const struct pwm_ops iqs620_pwm_ops = { |
| .apply = iqs620_pwm_apply, |
| .get_state = iqs620_pwm_get_state, |
| .owner = THIS_MODULE, |
| }; |
| |
| static void iqs620_pwm_notifier_unregister(void *context) |
| { |
| struct iqs620_pwm_private *iqs620_pwm = context; |
| int ret; |
| |
| ret = blocking_notifier_chain_unregister(&iqs620_pwm->iqs62x->nh, |
| &iqs620_pwm->notifier); |
| if (ret) |
| dev_err(iqs620_pwm->chip.dev, |
| "Failed to unregister notifier: %d\n", ret); |
| } |
| |
| static int iqs620_pwm_probe(struct platform_device *pdev) |
| { |
| struct iqs62x_core *iqs62x = dev_get_drvdata(pdev->dev.parent); |
| struct iqs620_pwm_private *iqs620_pwm; |
| unsigned int val; |
| int ret; |
| |
| iqs620_pwm = devm_kzalloc(&pdev->dev, sizeof(*iqs620_pwm), GFP_KERNEL); |
| if (!iqs620_pwm) |
| return -ENOMEM; |
| |
| platform_set_drvdata(pdev, iqs620_pwm); |
| iqs620_pwm->iqs62x = iqs62x; |
| |
| ret = regmap_read(iqs62x->regmap, IQS620_PWR_SETTINGS, &val); |
| if (ret) |
| return ret; |
| iqs620_pwm->out_en = val & IQS620_PWR_SETTINGS_PWM_OUT; |
| |
| ret = regmap_read(iqs62x->regmap, IQS620_PWM_DUTY_CYCLE, &val); |
| if (ret) |
| return ret; |
| iqs620_pwm->duty_val = val; |
| |
| iqs620_pwm->chip.dev = &pdev->dev; |
| iqs620_pwm->chip.ops = &iqs620_pwm_ops; |
| iqs620_pwm->chip.base = -1; |
| iqs620_pwm->chip.npwm = 1; |
| |
| mutex_init(&iqs620_pwm->lock); |
| |
| iqs620_pwm->notifier.notifier_call = iqs620_pwm_notifier; |
| ret = blocking_notifier_chain_register(&iqs620_pwm->iqs62x->nh, |
| &iqs620_pwm->notifier); |
| if (ret) { |
| dev_err(&pdev->dev, "Failed to register notifier: %d\n", ret); |
| return ret; |
| } |
| |
| ret = devm_add_action_or_reset(&pdev->dev, |
| iqs620_pwm_notifier_unregister, |
| iqs620_pwm); |
| if (ret) |
| return ret; |
| |
| ret = pwmchip_add(&iqs620_pwm->chip); |
| if (ret) |
| dev_err(&pdev->dev, "Failed to add device: %d\n", ret); |
| |
| return ret; |
| } |
| |
| static int iqs620_pwm_remove(struct platform_device *pdev) |
| { |
| struct iqs620_pwm_private *iqs620_pwm = platform_get_drvdata(pdev); |
| int ret; |
| |
| ret = pwmchip_remove(&iqs620_pwm->chip); |
| if (ret) |
| dev_err(&pdev->dev, "Failed to remove device: %d\n", ret); |
| |
| return ret; |
| } |
| |
| static struct platform_driver iqs620_pwm_platform_driver = { |
| .driver = { |
| .name = "iqs620a-pwm", |
| }, |
| .probe = iqs620_pwm_probe, |
| .remove = iqs620_pwm_remove, |
| }; |
| module_platform_driver(iqs620_pwm_platform_driver); |
| |
| MODULE_AUTHOR("Jeff LaBundy <jeff@labundy.com>"); |
| MODULE_DESCRIPTION("Azoteq IQS620A PWM Generator"); |
| MODULE_LICENSE("GPL"); |
| MODULE_ALIAS("platform:iqs620a-pwm"); |