| ================== |
| Leds BlinkM driver |
| ================== |
| |
| The leds-blinkm driver supports the devices of the BlinkM family. |
| |
| They are RGB-LED modules driven by a (AT)tiny microcontroller and |
| communicate through I2C. The default address of these modules is |
| 0x09 but this can be changed through a command. By this you could |
| daisy-chain up to 127 BlinkMs on an I2C bus. |
| |
| The device accepts RGB and HSB color values through separate commands. |
| Also you can store blinking sequences as "scripts" in |
| the controller and run them. Also fading is an option. |
| |
| The interface this driver provides is 2-fold: |
| |
| a) LED class interface for use with triggers |
| ############################################ |
| |
| The registration follows the scheme:: |
| |
| blinkm-<i2c-bus-nr>-<i2c-device-nr>-<color> |
| |
| $ ls -h /sys/class/leds/blinkm-6-* |
| /sys/class/leds/blinkm-6-9-blue: |
| brightness device max_brightness power subsystem trigger uevent |
| |
| /sys/class/leds/blinkm-6-9-green: |
| brightness device max_brightness power subsystem trigger uevent |
| |
| /sys/class/leds/blinkm-6-9-red: |
| brightness device max_brightness power subsystem trigger uevent |
| |
| (same is /sys/bus/i2c/devices/6-0009/leds) |
| |
| We can control the colors separated into red, green and blue and |
| assign triggers on each color. |
| |
| E.g.:: |
| |
| $ cat blinkm-6-9-blue/brightness |
| 05 |
| |
| $ echo 200 > blinkm-6-9-blue/brightness |
| $ |
| |
| $ modprobe ledtrig-heartbeat |
| $ echo heartbeat > blinkm-6-9-green/trigger |
| $ |
| |
| |
| b) Sysfs group to control rgb, fade, hsb, scripts ... |
| ##################################################### |
| |
| This extended interface is available as folder blinkm |
| in the sysfs folder of the I2C device. |
| E.g. below /sys/bus/i2c/devices/6-0009/blinkm |
| |
| $ ls -h /sys/bus/i2c/devices/6-0009/blinkm/ |
| blue green red test |
| |
| Currently supported is just setting red, green, blue |
| and a test sequence. |
| |
| E.g.:: |
| |
| $ cat * |
| 00 |
| 00 |
| 00 |
| #Write into test to start test sequence!# |
| |
| $ echo 1 > test |
| $ |
| |
| $ echo 255 > red |
| $ |
| |
| |
| |
| as of 6/2012 |
| |
| dl9pf <at> gmx <dot> de |