| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * DRM driver for the HX8357D LCD controller |
| * |
| * Copyright 2018 Broadcom |
| * Copyright 2018 David Lechner <david@lechnology.com> |
| * Copyright 2016 Noralf Trønnes |
| * Copyright (C) 2015 Adafruit Industries |
| * Copyright (C) 2013 Christian Vogelgsang |
| */ |
| |
| #include <linux/backlight.h> |
| #include <linux/delay.h> |
| #include <linux/gpio/consumer.h> |
| #include <linux/module.h> |
| #include <linux/property.h> |
| #include <linux/spi/spi.h> |
| |
| #include <drm/drm_atomic_helper.h> |
| #include <drm/drm_drv.h> |
| #include <drm/drm_fbdev_dma.h> |
| #include <drm/drm_gem_atomic_helper.h> |
| #include <drm/drm_gem_dma_helper.h> |
| #include <drm/drm_managed.h> |
| #include <drm/drm_mipi_dbi.h> |
| #include <drm/drm_modeset_helper.h> |
| #include <video/mipi_display.h> |
| |
| #define HX8357D_SETOSC 0xb0 |
| #define HX8357D_SETPOWER 0xb1 |
| #define HX8357D_SETRGB 0xb3 |
| #define HX8357D_SETCYC 0xb3 |
| #define HX8357D_SETCOM 0xb6 |
| #define HX8357D_SETEXTC 0xb9 |
| #define HX8357D_SETSTBA 0xc0 |
| #define HX8357D_SETPANEL 0xcc |
| #define HX8357D_SETGAMMA 0xe0 |
| |
| #define HX8357D_MADCTL_MY 0x80 |
| #define HX8357D_MADCTL_MX 0x40 |
| #define HX8357D_MADCTL_MV 0x20 |
| #define HX8357D_MADCTL_ML 0x10 |
| #define HX8357D_MADCTL_RGB 0x00 |
| #define HX8357D_MADCTL_BGR 0x08 |
| #define HX8357D_MADCTL_MH 0x04 |
| |
| static void yx240qv29_enable(struct drm_simple_display_pipe *pipe, |
| struct drm_crtc_state *crtc_state, |
| struct drm_plane_state *plane_state) |
| { |
| struct mipi_dbi_dev *dbidev = drm_to_mipi_dbi_dev(pipe->crtc.dev); |
| struct mipi_dbi *dbi = &dbidev->dbi; |
| u8 addr_mode; |
| int ret, idx; |
| |
| if (!drm_dev_enter(pipe->crtc.dev, &idx)) |
| return; |
| |
| DRM_DEBUG_KMS("\n"); |
| |
| ret = mipi_dbi_poweron_conditional_reset(dbidev); |
| if (ret < 0) |
| goto out_exit; |
| if (ret == 1) |
| goto out_enable; |
| |
| /* setextc */ |
| mipi_dbi_command(dbi, HX8357D_SETEXTC, 0xFF, 0x83, 0x57); |
| msleep(150); |
| |
| /* setRGB which also enables SDO */ |
| mipi_dbi_command(dbi, HX8357D_SETRGB, 0x00, 0x00, 0x06, 0x06); |
| |
| /* -1.52V */ |
| mipi_dbi_command(dbi, HX8357D_SETCOM, 0x25); |
| |
| /* Normal mode 70Hz, Idle mode 55 Hz */ |
| mipi_dbi_command(dbi, HX8357D_SETOSC, 0x68); |
| |
| /* Set Panel - BGR, Gate direction swapped */ |
| mipi_dbi_command(dbi, HX8357D_SETPANEL, 0x05); |
| |
| mipi_dbi_command(dbi, HX8357D_SETPOWER, |
| 0x00, /* Not deep standby */ |
| 0x15, /* BT */ |
| 0x1C, /* VSPR */ |
| 0x1C, /* VSNR */ |
| 0x83, /* AP */ |
| 0xAA); /* FS */ |
| |
| mipi_dbi_command(dbi, HX8357D_SETSTBA, |
| 0x50, /* OPON normal */ |
| 0x50, /* OPON idle */ |
| 0x01, /* STBA */ |
| 0x3C, /* STBA */ |
| 0x1E, /* STBA */ |
| 0x08); /* GEN */ |
| |
| mipi_dbi_command(dbi, HX8357D_SETCYC, |
| 0x02, /* NW 0x02 */ |
| 0x40, /* RTN */ |
| 0x00, /* DIV */ |
| 0x2A, /* DUM */ |
| 0x2A, /* DUM */ |
| 0x0D, /* GDON */ |
| 0x78); /* GDOFF */ |
| |
| mipi_dbi_command(dbi, HX8357D_SETGAMMA, |
| 0x02, |
| 0x0A, |
| 0x11, |
| 0x1d, |
| 0x23, |
| 0x35, |
| 0x41, |
| 0x4b, |
| 0x4b, |
| 0x42, |
| 0x3A, |
| 0x27, |
| 0x1B, |
| 0x08, |
| 0x09, |
| 0x03, |
| 0x02, |
| 0x0A, |
| 0x11, |
| 0x1d, |
| 0x23, |
| 0x35, |
| 0x41, |
| 0x4b, |
| 0x4b, |
| 0x42, |
| 0x3A, |
| 0x27, |
| 0x1B, |
| 0x08, |
| 0x09, |
| 0x03, |
| 0x00, |
| 0x01); |
| |
| /* 16 bit */ |
| mipi_dbi_command(dbi, MIPI_DCS_SET_PIXEL_FORMAT, |
| MIPI_DCS_PIXEL_FMT_16BIT); |
| |
| /* TE off */ |
| mipi_dbi_command(dbi, MIPI_DCS_SET_TEAR_ON, 0x00); |
| |
| /* tear line */ |
| mipi_dbi_command(dbi, MIPI_DCS_SET_TEAR_SCANLINE, 0x00, 0x02); |
| |
| /* Exit Sleep */ |
| mipi_dbi_command(dbi, MIPI_DCS_EXIT_SLEEP_MODE); |
| msleep(150); |
| |
| /* display on */ |
| mipi_dbi_command(dbi, MIPI_DCS_SET_DISPLAY_ON); |
| usleep_range(5000, 7000); |
| |
| out_enable: |
| switch (dbidev->rotation) { |
| default: |
| addr_mode = HX8357D_MADCTL_MX | HX8357D_MADCTL_MY; |
| break; |
| case 90: |
| addr_mode = HX8357D_MADCTL_MV | HX8357D_MADCTL_MY; |
| break; |
| case 180: |
| addr_mode = 0; |
| break; |
| case 270: |
| addr_mode = HX8357D_MADCTL_MV | HX8357D_MADCTL_MX; |
| break; |
| } |
| mipi_dbi_command(dbi, MIPI_DCS_SET_ADDRESS_MODE, addr_mode); |
| mipi_dbi_enable_flush(dbidev, crtc_state, plane_state); |
| out_exit: |
| drm_dev_exit(idx); |
| } |
| |
| static const struct drm_simple_display_pipe_funcs hx8357d_pipe_funcs = { |
| DRM_MIPI_DBI_SIMPLE_DISPLAY_PIPE_FUNCS(yx240qv29_enable), |
| }; |
| |
| static const struct drm_display_mode yx350hv15_mode = { |
| DRM_SIMPLE_MODE(320, 480, 60, 75), |
| }; |
| |
| DEFINE_DRM_GEM_DMA_FOPS(hx8357d_fops); |
| |
| static const struct drm_driver hx8357d_driver = { |
| .driver_features = DRIVER_GEM | DRIVER_MODESET | DRIVER_ATOMIC, |
| .fops = &hx8357d_fops, |
| DRM_GEM_DMA_DRIVER_OPS_VMAP, |
| .debugfs_init = mipi_dbi_debugfs_init, |
| .name = "hx8357d", |
| .desc = "HX8357D", |
| .date = "20181023", |
| .major = 1, |
| .minor = 0, |
| }; |
| |
| static const struct of_device_id hx8357d_of_match[] = { |
| { .compatible = "adafruit,yx350hv15" }, |
| { } |
| }; |
| MODULE_DEVICE_TABLE(of, hx8357d_of_match); |
| |
| static const struct spi_device_id hx8357d_id[] = { |
| { "yx350hv15", 0 }, |
| { } |
| }; |
| MODULE_DEVICE_TABLE(spi, hx8357d_id); |
| |
| static int hx8357d_probe(struct spi_device *spi) |
| { |
| struct device *dev = &spi->dev; |
| struct mipi_dbi_dev *dbidev; |
| struct drm_device *drm; |
| struct gpio_desc *dc; |
| u32 rotation = 0; |
| int ret; |
| |
| dbidev = devm_drm_dev_alloc(dev, &hx8357d_driver, |
| struct mipi_dbi_dev, drm); |
| if (IS_ERR(dbidev)) |
| return PTR_ERR(dbidev); |
| |
| drm = &dbidev->drm; |
| |
| dc = devm_gpiod_get(dev, "dc", GPIOD_OUT_LOW); |
| if (IS_ERR(dc)) |
| return dev_err_probe(dev, PTR_ERR(dc), "Failed to get GPIO 'dc'\n"); |
| |
| dbidev->backlight = devm_of_find_backlight(dev); |
| if (IS_ERR(dbidev->backlight)) |
| return PTR_ERR(dbidev->backlight); |
| |
| device_property_read_u32(dev, "rotation", &rotation); |
| |
| ret = mipi_dbi_spi_init(spi, &dbidev->dbi, dc); |
| if (ret) |
| return ret; |
| |
| ret = mipi_dbi_dev_init(dbidev, &hx8357d_pipe_funcs, &yx350hv15_mode, rotation); |
| if (ret) |
| return ret; |
| |
| drm_mode_config_reset(drm); |
| |
| ret = drm_dev_register(drm, 0); |
| if (ret) |
| return ret; |
| |
| spi_set_drvdata(spi, drm); |
| |
| drm_fbdev_dma_setup(drm, 0); |
| |
| return 0; |
| } |
| |
| static void hx8357d_remove(struct spi_device *spi) |
| { |
| struct drm_device *drm = spi_get_drvdata(spi); |
| |
| drm_dev_unplug(drm); |
| drm_atomic_helper_shutdown(drm); |
| } |
| |
| static void hx8357d_shutdown(struct spi_device *spi) |
| { |
| drm_atomic_helper_shutdown(spi_get_drvdata(spi)); |
| } |
| |
| static struct spi_driver hx8357d_spi_driver = { |
| .driver = { |
| .name = "hx8357d", |
| .of_match_table = hx8357d_of_match, |
| }, |
| .id_table = hx8357d_id, |
| .probe = hx8357d_probe, |
| .remove = hx8357d_remove, |
| .shutdown = hx8357d_shutdown, |
| }; |
| module_spi_driver(hx8357d_spi_driver); |
| |
| MODULE_DESCRIPTION("HX8357D DRM driver"); |
| MODULE_AUTHOR("Eric Anholt <eric@anholt.net>"); |
| MODULE_LICENSE("GPL"); |