blob: b94e210c7795ea75e9db0058dad3784a3ae0d923 [file] [log] [blame] [edit]
# SPDX-License-Identifier: GPL-2.0-only
#
# GNSS receiver configuration
#
menuconfig GNSS
tristate "GNSS receiver support"
help
Say Y here if you have a GNSS receiver (e.g. a GPS receiver).
To compile this driver as a module, choose M here: the module will
be called gnss.
if GNSS
config GNSS_SERIAL
tristate
config GNSS_MTK_SERIAL
tristate "Mediatek GNSS receiver support"
depends on SERIAL_DEV_BUS
select GNSS_SERIAL
help
Say Y here if you have a Mediatek-based GNSS receiver which uses a
serial interface.
To compile this driver as a module, choose M here: the module will
be called gnss-mtk.
If unsure, say N.
config GNSS_SIRF_SERIAL
tristate "SiRFstar GNSS receiver support"
depends on SERIAL_DEV_BUS
help
Say Y here if you have a SiRFstar-based GNSS receiver which uses a
serial interface.
To compile this driver as a module, choose M here: the module will
be called gnss-sirf.
If unsure, say N.
config GNSS_UBX_SERIAL
tristate "u-blox GNSS receiver support"
depends on SERIAL_DEV_BUS
select GNSS_SERIAL
help
Say Y here if you have a u-blox GNSS receiver which uses a serial
interface.
To compile this driver as a module, choose M here: the module will
be called gnss-ubx.
If unsure, say N.
config GNSS_CMDLINE_SERIAL
tristate "Command line test driver for GNSS"
depends on SERIAL_DEV_BUS
select GNSS_SERIAL
help
Say Y here if you want to test the GNSS subsystem but do not have a
way to communicate a binding through firmware such as DT or ACPI.
The correct serdev device and protocol type must be specified on
the module command line.
To compile this driver as a module, choose M here: the module will
be called gnss-cmdline.
If unsure, say N.
endif # GNSS