| # SPDX-License-Identifier: GPL-2.0-only |
| menu "Broadcom PM Domains" |
| |
| config BCM2835_POWER |
| bool "BCM2835 power domain driver" |
| depends on ARCH_BCM2835 || (COMPILE_TEST && OF) |
| default y if ARCH_BCM2835 |
| select PM_GENERIC_DOMAINS if PM |
| select RESET_CONTROLLER |
| help |
| This enables support for the BCM2835 power domains and reset |
| controller. Any usage of power domains by the Raspberry Pi |
| firmware means that Linux usage of the same power domain |
| must be accessed using the RASPBERRYPI_POWER driver |
| |
| config RASPBERRYPI_POWER |
| bool "Raspberry Pi power domain driver" |
| depends on ARCH_BCM2835 || (COMPILE_TEST && OF) |
| depends on RASPBERRYPI_FIRMWARE=y |
| select PM_GENERIC_DOMAINS if PM |
| help |
| This enables support for the RPi power domains which can be enabled |
| or disabled via the RPi firmware. |
| |
| config BCM_PMB |
| bool "Broadcom PMB (Power Management Bus) driver" |
| depends on ARCH_BCMBCA || (COMPILE_TEST && OF) |
| default ARCH_BCMBCA |
| select PM_GENERIC_DOMAINS if PM |
| help |
| This enables support for the Broadcom's PMB (Power Management Bus) that |
| is used for disabling and enabling SoC devices. |
| |
| config BCM63XX_POWER |
| bool "BCM63xx power domain driver" |
| depends on BMIPS_GENERIC || (COMPILE_TEST && OF) |
| select PM_GENERIC_DOMAINS if PM |
| help |
| This enables support for the BCM63xx power domains controller on |
| BCM6318, BCM6328, BCM6362 and BCM63268 SoCs. |
| |
| endmenu |
