| // SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause |
| /* Copyright (c) 2015, The Linux Foundation. All rights reserved. */ |
| /* Copyright (c) 2020 Sartura Ltd. */ |
| |
| #include <linux/delay.h> |
| #include <linux/io.h> |
| #include <linux/iopoll.h> |
| #include <linux/kernel.h> |
| #include <linux/module.h> |
| #include <linux/of_address.h> |
| #include <linux/of_mdio.h> |
| #include <linux/phy.h> |
| #include <linux/platform_device.h> |
| #include <linux/clk.h> |
| |
| #define MDIO_MODE_REG 0x40 |
| #define MDIO_ADDR_REG 0x44 |
| #define MDIO_DATA_WRITE_REG 0x48 |
| #define MDIO_DATA_READ_REG 0x4c |
| #define MDIO_CMD_REG 0x50 |
| #define MDIO_CMD_ACCESS_BUSY BIT(16) |
| #define MDIO_CMD_ACCESS_START BIT(8) |
| #define MDIO_CMD_ACCESS_CODE_READ 0 |
| #define MDIO_CMD_ACCESS_CODE_WRITE 1 |
| #define MDIO_CMD_ACCESS_CODE_C45_ADDR 0 |
| #define MDIO_CMD_ACCESS_CODE_C45_WRITE 1 |
| #define MDIO_CMD_ACCESS_CODE_C45_READ 2 |
| |
| /* 0 = Clause 22, 1 = Clause 45 */ |
| #define MDIO_MODE_C45 BIT(8) |
| |
| #define IPQ4019_MDIO_TIMEOUT 10000 |
| #define IPQ4019_MDIO_SLEEP 10 |
| |
| /* MDIO clock source frequency is fixed to 100M */ |
| #define IPQ_MDIO_CLK_RATE 100000000 |
| |
| #define IPQ_PHY_SET_DELAY_US 100000 |
| |
| struct ipq4019_mdio_data { |
| void __iomem *membase; |
| void __iomem *eth_ldo_rdy; |
| struct clk *mdio_clk; |
| }; |
| |
| static int ipq4019_mdio_wait_busy(struct mii_bus *bus) |
| { |
| struct ipq4019_mdio_data *priv = bus->priv; |
| unsigned int busy; |
| |
| return readl_poll_timeout(priv->membase + MDIO_CMD_REG, busy, |
| (busy & MDIO_CMD_ACCESS_BUSY) == 0, |
| IPQ4019_MDIO_SLEEP, IPQ4019_MDIO_TIMEOUT); |
| } |
| |
| static int ipq4019_mdio_read_c45(struct mii_bus *bus, int mii_id, int mmd, |
| int reg) |
| { |
| struct ipq4019_mdio_data *priv = bus->priv; |
| unsigned int data; |
| unsigned int cmd; |
| |
| if (ipq4019_mdio_wait_busy(bus)) |
| return -ETIMEDOUT; |
| |
| data = readl(priv->membase + MDIO_MODE_REG); |
| |
| data |= MDIO_MODE_C45; |
| |
| writel(data, priv->membase + MDIO_MODE_REG); |
| |
| /* issue the phy address and mmd */ |
| writel((mii_id << 8) | mmd, priv->membase + MDIO_ADDR_REG); |
| |
| /* issue reg */ |
| writel(reg, priv->membase + MDIO_DATA_WRITE_REG); |
| |
| cmd = MDIO_CMD_ACCESS_START | MDIO_CMD_ACCESS_CODE_C45_ADDR; |
| |
| /* issue read command */ |
| writel(cmd, priv->membase + MDIO_CMD_REG); |
| |
| /* Wait read complete */ |
| if (ipq4019_mdio_wait_busy(bus)) |
| return -ETIMEDOUT; |
| |
| cmd = MDIO_CMD_ACCESS_START | MDIO_CMD_ACCESS_CODE_C45_READ; |
| |
| writel(cmd, priv->membase + MDIO_CMD_REG); |
| |
| if (ipq4019_mdio_wait_busy(bus)) |
| return -ETIMEDOUT; |
| |
| /* Read and return data */ |
| return readl(priv->membase + MDIO_DATA_READ_REG); |
| } |
| |
| static int ipq4019_mdio_read_c22(struct mii_bus *bus, int mii_id, int regnum) |
| { |
| struct ipq4019_mdio_data *priv = bus->priv; |
| unsigned int data; |
| unsigned int cmd; |
| |
| if (ipq4019_mdio_wait_busy(bus)) |
| return -ETIMEDOUT; |
| |
| data = readl(priv->membase + MDIO_MODE_REG); |
| |
| data &= ~MDIO_MODE_C45; |
| |
| writel(data, priv->membase + MDIO_MODE_REG); |
| |
| /* issue the phy address and reg */ |
| writel((mii_id << 8) | regnum, priv->membase + MDIO_ADDR_REG); |
| |
| cmd = MDIO_CMD_ACCESS_START | MDIO_CMD_ACCESS_CODE_READ; |
| |
| /* issue read command */ |
| writel(cmd, priv->membase + MDIO_CMD_REG); |
| |
| /* Wait read complete */ |
| if (ipq4019_mdio_wait_busy(bus)) |
| return -ETIMEDOUT; |
| |
| /* Read and return data */ |
| return readl(priv->membase + MDIO_DATA_READ_REG); |
| } |
| |
| static int ipq4019_mdio_write_c45(struct mii_bus *bus, int mii_id, int mmd, |
| int reg, u16 value) |
| { |
| struct ipq4019_mdio_data *priv = bus->priv; |
| unsigned int data; |
| unsigned int cmd; |
| |
| if (ipq4019_mdio_wait_busy(bus)) |
| return -ETIMEDOUT; |
| |
| data = readl(priv->membase + MDIO_MODE_REG); |
| |
| data |= MDIO_MODE_C45; |
| |
| writel(data, priv->membase + MDIO_MODE_REG); |
| |
| /* issue the phy address and mmd */ |
| writel((mii_id << 8) | mmd, priv->membase + MDIO_ADDR_REG); |
| |
| /* issue reg */ |
| writel(reg, priv->membase + MDIO_DATA_WRITE_REG); |
| |
| cmd = MDIO_CMD_ACCESS_START | MDIO_CMD_ACCESS_CODE_C45_ADDR; |
| |
| writel(cmd, priv->membase + MDIO_CMD_REG); |
| |
| if (ipq4019_mdio_wait_busy(bus)) |
| return -ETIMEDOUT; |
| |
| /* issue write data */ |
| writel(value, priv->membase + MDIO_DATA_WRITE_REG); |
| |
| cmd = MDIO_CMD_ACCESS_START | MDIO_CMD_ACCESS_CODE_C45_WRITE; |
| writel(cmd, priv->membase + MDIO_CMD_REG); |
| |
| /* Wait write complete */ |
| if (ipq4019_mdio_wait_busy(bus)) |
| return -ETIMEDOUT; |
| |
| return 0; |
| } |
| |
| static int ipq4019_mdio_write_c22(struct mii_bus *bus, int mii_id, int regnum, |
| u16 value) |
| { |
| struct ipq4019_mdio_data *priv = bus->priv; |
| unsigned int data; |
| unsigned int cmd; |
| |
| if (ipq4019_mdio_wait_busy(bus)) |
| return -ETIMEDOUT; |
| |
| /* Enter Clause 22 mode */ |
| data = readl(priv->membase + MDIO_MODE_REG); |
| |
| data &= ~MDIO_MODE_C45; |
| |
| writel(data, priv->membase + MDIO_MODE_REG); |
| |
| /* issue the phy address and reg */ |
| writel((mii_id << 8) | regnum, priv->membase + MDIO_ADDR_REG); |
| |
| /* issue write data */ |
| writel(value, priv->membase + MDIO_DATA_WRITE_REG); |
| |
| /* issue write command */ |
| cmd = MDIO_CMD_ACCESS_START | MDIO_CMD_ACCESS_CODE_WRITE; |
| |
| writel(cmd, priv->membase + MDIO_CMD_REG); |
| |
| /* Wait write complete */ |
| if (ipq4019_mdio_wait_busy(bus)) |
| return -ETIMEDOUT; |
| |
| return 0; |
| } |
| |
| static int ipq_mdio_reset(struct mii_bus *bus) |
| { |
| struct ipq4019_mdio_data *priv = bus->priv; |
| u32 val; |
| int ret; |
| |
| /* To indicate CMN_PLL that ethernet_ldo has been ready if platform resource 1 |
| * is specified in the device tree. |
| */ |
| if (priv->eth_ldo_rdy) { |
| val = readl(priv->eth_ldo_rdy); |
| val |= BIT(0); |
| writel(val, priv->eth_ldo_rdy); |
| fsleep(IPQ_PHY_SET_DELAY_US); |
| } |
| |
| /* Configure MDIO clock source frequency if clock is specified in the device tree */ |
| ret = clk_set_rate(priv->mdio_clk, IPQ_MDIO_CLK_RATE); |
| if (ret) |
| return ret; |
| |
| ret = clk_prepare_enable(priv->mdio_clk); |
| if (ret == 0) |
| mdelay(10); |
| |
| return ret; |
| } |
| |
| static int ipq4019_mdio_probe(struct platform_device *pdev) |
| { |
| struct ipq4019_mdio_data *priv; |
| struct mii_bus *bus; |
| struct resource *res; |
| int ret; |
| |
| bus = devm_mdiobus_alloc_size(&pdev->dev, sizeof(*priv)); |
| if (!bus) |
| return -ENOMEM; |
| |
| priv = bus->priv; |
| |
| priv->membase = devm_platform_ioremap_resource(pdev, 0); |
| if (IS_ERR(priv->membase)) |
| return PTR_ERR(priv->membase); |
| |
| priv->mdio_clk = devm_clk_get_optional(&pdev->dev, "gcc_mdio_ahb_clk"); |
| if (IS_ERR(priv->mdio_clk)) |
| return PTR_ERR(priv->mdio_clk); |
| |
| /* The platform resource is provided on the chipset IPQ5018 */ |
| /* This resource is optional */ |
| res = platform_get_resource(pdev, IORESOURCE_MEM, 1); |
| if (res) |
| priv->eth_ldo_rdy = devm_ioremap_resource(&pdev->dev, res); |
| |
| bus->name = "ipq4019_mdio"; |
| bus->read = ipq4019_mdio_read_c22; |
| bus->write = ipq4019_mdio_write_c22; |
| bus->read_c45 = ipq4019_mdio_read_c45; |
| bus->write_c45 = ipq4019_mdio_write_c45; |
| bus->reset = ipq_mdio_reset; |
| bus->parent = &pdev->dev; |
| snprintf(bus->id, MII_BUS_ID_SIZE, "%s%d", pdev->name, pdev->id); |
| |
| ret = of_mdiobus_register(bus, pdev->dev.of_node); |
| if (ret) { |
| dev_err(&pdev->dev, "Cannot register MDIO bus!\n"); |
| return ret; |
| } |
| |
| platform_set_drvdata(pdev, bus); |
| |
| return 0; |
| } |
| |
| static int ipq4019_mdio_remove(struct platform_device *pdev) |
| { |
| struct mii_bus *bus = platform_get_drvdata(pdev); |
| |
| mdiobus_unregister(bus); |
| |
| return 0; |
| } |
| |
| static const struct of_device_id ipq4019_mdio_dt_ids[] = { |
| { .compatible = "qcom,ipq4019-mdio" }, |
| { .compatible = "qcom,ipq5018-mdio" }, |
| { } |
| }; |
| MODULE_DEVICE_TABLE(of, ipq4019_mdio_dt_ids); |
| |
| static struct platform_driver ipq4019_mdio_driver = { |
| .probe = ipq4019_mdio_probe, |
| .remove = ipq4019_mdio_remove, |
| .driver = { |
| .name = "ipq4019-mdio", |
| .of_match_table = ipq4019_mdio_dt_ids, |
| }, |
| }; |
| |
| module_platform_driver(ipq4019_mdio_driver); |
| |
| MODULE_DESCRIPTION("ipq4019 MDIO interface driver"); |
| MODULE_AUTHOR("Qualcomm Atheros"); |
| MODULE_LICENSE("Dual BSD/GPL"); |