| .. SPDX-License-Identifier: GPL-2.0-or-later |
| |
| Kernel driver corsair-cpro |
| ========================== |
| |
| Supported devices: |
| |
| * Corsair Commander Pro |
| * Corsair Commander Pro (1000D) |
| |
| Author: Marius Zachmann |
| |
| Description |
| ----------- |
| |
| This driver implements the sysfs interface for the Corsair Commander Pro. |
| The Corsair Commander Pro is a USB device with 6 fan connectors, |
| 4 temperature sensor connectors and 2 Corsair LED connectors. |
| It can read the voltage levels on the SATA power connector. |
| |
| Usage Notes |
| ----------- |
| |
| Since it is a USB device, hotswapping is possible. The device is autodetected. |
| |
| Sysfs entries |
| ------------- |
| |
| ======================= ===================================================================== |
| in0_input Voltage on SATA 12v |
| in1_input Voltage on SATA 5v |
| in2_input Voltage on SATA 3.3v |
| temp[1-4]_input Temperature on connected temperature sensors |
| fan[1-6]_input Connected fan rpm. |
| fan[1-6]_label Shows fan type as detected by the device. |
| fan[1-6]_target Sets fan speed target rpm. |
| When reading, it reports the last value if it was set by the driver. |
| Otherwise returns an error. |
| pwm[1-6] Sets the fan speed. Values from 0-255. Can only be read if pwm |
| was set directly. |
| ======================= ===================================================================== |
