blob: 20d4c020a83c1f7566533e0e8de5b7cd796415ad [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright (c) 2014-2023, The Linux Foundation. All rights reserved.
*/
#include <linux/clk.h>
#include <linux/delay.h>
#include <linux/err.h>
#include <linux/io.h>
#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/of.h>
#include <linux/phy/phy.h>
#include <linux/platform_device.h>
#include <linux/reset.h>
#include <linux/slab.h>
#define USB2PHY_PORT_UTMI_CTRL1 0x40
#define USB2PHY_PORT_UTMI_CTRL2 0x44
#define UTMI_ULPI_SEL BIT(7)
#define UTMI_TEST_MUX_SEL BIT(6)
#define HS_PHY_CTRL_REG 0x10
#define UTMI_OTG_VBUS_VALID BIT(20)
#define SW_SESSVLD_SEL BIT(28)
#define USB_PHY_UTMI_CTRL0 0x3c
#define USB_PHY_UTMI_CTRL5 0x50
#define POR_EN BIT(1)
#define USB_PHY_HS_PHY_CTRL_COMMON0 0x54
#define COMMONONN BIT(7)
#define FSEL BIT(4)
#define RETENABLEN BIT(3)
#define FREQ_24MHZ (BIT(6) | BIT(4))
#define USB_PHY_HS_PHY_CTRL2 0x64
#define USB2_SUSPEND_N_SEL BIT(3)
#define USB2_SUSPEND_N BIT(2)
#define USB2_UTMI_CLK_EN BIT(1)
#define USB_PHY_CFG0 0x94
#define UTMI_PHY_OVERRIDE_EN BIT(1)
#define USB_PHY_REFCLK_CTRL 0xa0
#define CLKCORE BIT(1)
#define USB2PHY_PORT_POWERDOWN 0xa4
#define POWER_UP BIT(0)
#define POWER_DOWN 0
#define USB_PHY_FSEL_SEL 0xb8
#define FREQ_SEL BIT(0)
#define USB2PHY_USB_PHY_M31_XCFGI_1 0xbc
#define USB2_0_TX_ENABLE BIT(2)
#define USB2PHY_USB_PHY_M31_XCFGI_4 0xc8
#define HSTX_SLEW_RATE_565PS GENMASK(1, 0)
#define PLL_CHARGING_PUMP_CURRENT_35UA GENMASK(4, 3)
#define ODT_VALUE_38_02_OHM GENMASK(7, 6)
#define USB2PHY_USB_PHY_M31_XCFGI_5 0xcc
#define ODT_VALUE_45_02_OHM BIT(2)
#define HSTX_PRE_EMPHASIS_LEVEL_0_55MA BIT(0)
#define USB2PHY_USB_PHY_M31_XCFGI_11 0xe4
#define XCFG_COARSE_TUNE_NUM BIT(1)
#define XCFG_FINE_TUNE_NUM BIT(3)
struct m31_phy_regs {
u32 off;
u32 val;
u32 delay;
};
struct m31_priv_data {
bool ulpi_mode;
const struct m31_phy_regs *regs;
unsigned int nregs;
};
static const struct m31_phy_regs m31_ipq5018_regs[] = {
{
.off = USB_PHY_CFG0,
.val = UTMI_PHY_OVERRIDE_EN
},
{
.off = USB_PHY_UTMI_CTRL5,
.val = POR_EN,
.delay = 15
},
{
.off = USB_PHY_FSEL_SEL,
.val = FREQ_SEL
},
{
.off = USB_PHY_HS_PHY_CTRL_COMMON0,
.val = COMMONONN | FSEL | RETENABLEN
},
{
.off = USB_PHY_REFCLK_CTRL,
.val = CLKCORE
},
{
.off = USB_PHY_UTMI_CTRL5,
.val = POR_EN
},
{
.off = USB_PHY_HS_PHY_CTRL2,
.val = USB2_SUSPEND_N_SEL | USB2_SUSPEND_N | USB2_UTMI_CLK_EN
},
{
.off = USB_PHY_UTMI_CTRL5,
.val = 0x0
},
{
.off = USB_PHY_HS_PHY_CTRL2,
.val = USB2_SUSPEND_N | USB2_UTMI_CLK_EN
},
{
.off = USB_PHY_CFG0,
.val = 0x0
},
};
static struct m31_phy_regs m31_ipq5332_regs[] = {
{
USB_PHY_CFG0,
UTMI_PHY_OVERRIDE_EN,
0
},
{
USB_PHY_UTMI_CTRL5,
POR_EN,
15
},
{
USB_PHY_FSEL_SEL,
FREQ_SEL,
0
},
{
USB_PHY_HS_PHY_CTRL_COMMON0,
COMMONONN | FREQ_24MHZ | RETENABLEN,
0
},
{
USB_PHY_UTMI_CTRL5,
POR_EN,
0
},
{
USB_PHY_HS_PHY_CTRL2,
USB2_SUSPEND_N_SEL | USB2_SUSPEND_N | USB2_UTMI_CLK_EN,
0
},
{
USB2PHY_USB_PHY_M31_XCFGI_11,
XCFG_COARSE_TUNE_NUM | XCFG_FINE_TUNE_NUM,
0
},
{
USB2PHY_USB_PHY_M31_XCFGI_4,
HSTX_SLEW_RATE_565PS | PLL_CHARGING_PUMP_CURRENT_35UA | ODT_VALUE_38_02_OHM,
0
},
{
USB2PHY_USB_PHY_M31_XCFGI_1,
USB2_0_TX_ENABLE,
0
},
{
USB2PHY_USB_PHY_M31_XCFGI_5,
ODT_VALUE_45_02_OHM | HSTX_PRE_EMPHASIS_LEVEL_0_55MA,
4
},
{
USB_PHY_UTMI_CTRL5,
0x0,
0
},
{
USB_PHY_HS_PHY_CTRL2,
USB2_SUSPEND_N | USB2_UTMI_CLK_EN,
0
},
};
struct m31usb_phy {
struct phy *phy;
void __iomem *base;
const struct m31_phy_regs *regs;
int nregs;
struct regulator *vreg;
struct clk *clk;
struct reset_control *reset;
bool ulpi_mode;
};
static int m31usb_phy_init(struct phy *phy)
{
struct m31usb_phy *qphy = phy_get_drvdata(phy);
const struct m31_phy_regs *regs = qphy->regs;
int i, ret;
ret = regulator_enable(qphy->vreg);
if (ret) {
dev_err(&phy->dev, "failed to enable regulator, %d\n", ret);
return ret;
}
ret = clk_prepare_enable(qphy->clk);
if (ret) {
regulator_disable(qphy->vreg);
dev_err(&phy->dev, "failed to enable cfg ahb clock, %d\n", ret);
return ret;
}
/* Perform phy reset */
reset_control_assert(qphy->reset);
udelay(5);
reset_control_deassert(qphy->reset);
/* configure for ULPI mode if requested */
if (qphy->ulpi_mode)
writel(0x0, qphy->base + USB2PHY_PORT_UTMI_CTRL2);
/* Enable the PHY */
writel(POWER_UP, qphy->base + USB2PHY_PORT_POWERDOWN);
/* Turn on phy ref clock */
for (i = 0; i < qphy->nregs; i++) {
writel(regs[i].val, qphy->base + regs[i].off);
if (regs[i].delay)
udelay(regs[i].delay);
}
return 0;
}
static int m31usb_phy_shutdown(struct phy *phy)
{
struct m31usb_phy *qphy = phy_get_drvdata(phy);
/* Disable the PHY */
writel_relaxed(POWER_DOWN, qphy->base + USB2PHY_PORT_POWERDOWN);
clk_disable_unprepare(qphy->clk);
regulator_disable(qphy->vreg);
return 0;
}
static const struct phy_ops m31usb_phy_gen_ops = {
.power_on = m31usb_phy_init,
.power_off = m31usb_phy_shutdown,
.owner = THIS_MODULE,
};
static int m31usb_phy_probe(struct platform_device *pdev)
{
struct phy_provider *phy_provider;
const struct m31_priv_data *data;
struct device *dev = &pdev->dev;
struct m31usb_phy *qphy;
qphy = devm_kzalloc(dev, sizeof(*qphy), GFP_KERNEL);
if (!qphy)
return -ENOMEM;
qphy->base = devm_platform_ioremap_resource(pdev, 0);
if (IS_ERR(qphy->base))
return PTR_ERR(qphy->base);
qphy->reset = devm_reset_control_get_exclusive_by_index(dev, 0);
if (IS_ERR(qphy->reset))
return PTR_ERR(qphy->reset);
qphy->clk = devm_clk_get(dev, NULL);
if (IS_ERR(qphy->clk))
return dev_err_probe(dev, PTR_ERR(qphy->clk),
"failed to get clk\n");
data = of_device_get_match_data(dev);
qphy->regs = data->regs;
qphy->nregs = data->nregs;
qphy->ulpi_mode = data->ulpi_mode;
qphy->phy = devm_phy_create(dev, NULL, &m31usb_phy_gen_ops);
if (IS_ERR(qphy->phy))
return dev_err_probe(dev, PTR_ERR(qphy->phy),
"failed to create phy\n");
qphy->vreg = devm_regulator_get(dev, "vdd");
if (IS_ERR(qphy->vreg))
return dev_err_probe(dev, PTR_ERR(qphy->vreg),
"failed to get vreg\n");
phy_set_drvdata(qphy->phy, qphy);
phy_provider = devm_of_phy_provider_register(dev, of_phy_simple_xlate);
if (!IS_ERR(phy_provider))
dev_info(dev, "Registered M31 USB phy\n");
return PTR_ERR_OR_ZERO(phy_provider);
}
static const struct m31_priv_data m31_ipq5018_data = {
.ulpi_mode = false,
.regs = m31_ipq5018_regs,
.nregs = ARRAY_SIZE(m31_ipq5018_regs),
};
static const struct m31_priv_data m31_ipq5332_data = {
.ulpi_mode = false,
.regs = m31_ipq5332_regs,
.nregs = ARRAY_SIZE(m31_ipq5332_regs),
};
static const struct of_device_id m31usb_phy_id_table[] = {
{ .compatible = "qcom,ipq5018-usb-hsphy", .data = &m31_ipq5018_data },
{ .compatible = "qcom,ipq5332-usb-hsphy", .data = &m31_ipq5332_data },
{ },
};
MODULE_DEVICE_TABLE(of, m31usb_phy_id_table);
static struct platform_driver m31usb_phy_driver = {
.probe = m31usb_phy_probe,
.driver = {
.name = "qcom-m31usb-phy",
.of_match_table = m31usb_phy_id_table,
},
};
module_platform_driver(m31usb_phy_driver);
MODULE_DESCRIPTION("USB2 Qualcomm M31 HSPHY driver");
MODULE_LICENSE("GPL");