| // SPDX-License-Identifier: GPL-2.0 | 
 | // | 
 | // QiHeng Electronics ch341a USB-to-SPI adapter driver | 
 | // | 
 | // Copyright (C) 2024 Johannes Thumshirn <jth@kernel.org> | 
 | // | 
 | // Based on ch341a_spi.c from the flashrom project. | 
 |  | 
 | #include <linux/module.h> | 
 | #include <linux/usb.h> | 
 | #include <linux/spi/spi.h> | 
 |  | 
 | #define CH341_PACKET_LENGTH 32 | 
 | #define CH341_DEFAULT_TIMEOUT 1000 | 
 |  | 
 | #define CH341A_CMD_UIO_STREAM 0xab | 
 |  | 
 | #define CH341A_CMD_UIO_STM_END 0x20 | 
 | #define CH341A_CMD_UIO_STM_DIR 0x40 | 
 | #define CH341A_CMD_UIO_STM_OUT 0x80 | 
 |  | 
 | #define CH341A_CMD_I2C_STREAM 0xaa | 
 | #define CH341A_CMD_I2C_STM_SET 0x60 | 
 | #define CH341A_CMD_I2C_STM_END 0x00 | 
 |  | 
 | #define CH341A_CMD_SPI_STREAM 0xa8 | 
 |  | 
 | #define CH341A_STM_I2C_100K 0x01 | 
 |  | 
 | struct ch341_spi_dev { | 
 | 	struct spi_controller *ctrl; | 
 | 	struct usb_device *udev; | 
 | 	unsigned int write_pipe; | 
 | 	unsigned int read_pipe; | 
 | 	int rx_len; | 
 | 	void *rx_buf; | 
 | 	u8 *tx_buf; | 
 | 	struct urb *rx_urb; | 
 | 	struct spi_device *spidev; | 
 | }; | 
 |  | 
 | static void ch341_set_cs(struct spi_device *spi, bool is_high) | 
 | { | 
 | 	struct ch341_spi_dev *ch341 = | 
 | 		spi_controller_get_devdata(spi->controller); | 
 | 	int err; | 
 |  | 
 | 	memset(ch341->tx_buf, 0, CH341_PACKET_LENGTH); | 
 | 	ch341->tx_buf[0] = CH341A_CMD_UIO_STREAM; | 
 | 	ch341->tx_buf[1] = CH341A_CMD_UIO_STM_OUT | (is_high ? 0x36 : 0x37); | 
 |  | 
 | 	if (is_high) { | 
 | 		ch341->tx_buf[2] = CH341A_CMD_UIO_STM_DIR | 0x3f; | 
 | 		ch341->tx_buf[3] = CH341A_CMD_UIO_STM_END; | 
 | 	} else { | 
 | 		ch341->tx_buf[2] = CH341A_CMD_UIO_STM_END; | 
 | 	} | 
 |  | 
 | 	err = usb_bulk_msg(ch341->udev, ch341->write_pipe, ch341->tx_buf, | 
 | 			   (is_high ? 4 : 3), NULL, CH341_DEFAULT_TIMEOUT); | 
 | 	if (err) | 
 | 		dev_err(&spi->dev, | 
 | 			"error sending USB message for setting CS (%d)\n", err); | 
 | } | 
 |  | 
 | static int ch341_transfer_one(struct spi_controller *host, | 
 | 			      struct spi_device *spi, | 
 | 			      struct spi_transfer *trans) | 
 | { | 
 | 	struct ch341_spi_dev *ch341 = | 
 | 		spi_controller_get_devdata(spi->controller); | 
 | 	int len; | 
 | 	int ret; | 
 |  | 
 | 	len = min(CH341_PACKET_LENGTH, trans->len + 1); | 
 |  | 
 | 	memset(ch341->tx_buf, 0, CH341_PACKET_LENGTH); | 
 |  | 
 | 	ch341->tx_buf[0] = CH341A_CMD_SPI_STREAM; | 
 |  | 
 | 	memcpy(ch341->tx_buf + 1, trans->tx_buf, len); | 
 |  | 
 | 	ret = usb_bulk_msg(ch341->udev, ch341->write_pipe, ch341->tx_buf, len, | 
 | 			   NULL, CH341_DEFAULT_TIMEOUT); | 
 | 	if (ret) | 
 | 		return ret; | 
 |  | 
 | 	return usb_bulk_msg(ch341->udev, ch341->read_pipe, trans->rx_buf, | 
 | 			    len - 1, NULL, CH341_DEFAULT_TIMEOUT); | 
 | } | 
 |  | 
 | static void ch341_recv(struct urb *urb) | 
 | { | 
 | 	struct ch341_spi_dev *ch341 = urb->context; | 
 | 	struct usb_device *udev = ch341->udev; | 
 |  | 
 | 	switch (urb->status) { | 
 | 	case 0: | 
 | 		/* success */ | 
 | 		break; | 
 | 	case -ENOENT: | 
 | 	case -ECONNRESET: | 
 | 	case -EPIPE: | 
 | 	case -ESHUTDOWN: | 
 | 		dev_dbg(&udev->dev, "rx urb terminated with status: %d\n", | 
 | 			urb->status); | 
 | 		return; | 
 | 	default: | 
 | 		dev_dbg(&udev->dev, "rx urb error: %d\n", urb->status); | 
 | 		break; | 
 | 	} | 
 | } | 
 |  | 
 | static int ch341_config_stream(struct ch341_spi_dev *ch341) | 
 | { | 
 | 	memset(ch341->tx_buf, 0, CH341_PACKET_LENGTH); | 
 | 	ch341->tx_buf[0] = CH341A_CMD_I2C_STREAM; | 
 | 	ch341->tx_buf[1] = CH341A_CMD_I2C_STM_SET | CH341A_STM_I2C_100K; | 
 | 	ch341->tx_buf[2] = CH341A_CMD_I2C_STM_END; | 
 |  | 
 | 	return usb_bulk_msg(ch341->udev, ch341->write_pipe, ch341->tx_buf, 3, | 
 | 			    NULL, CH341_DEFAULT_TIMEOUT); | 
 | } | 
 |  | 
 | static int ch341_enable_pins(struct ch341_spi_dev *ch341, bool enable) | 
 | { | 
 | 	memset(ch341->tx_buf, 0, CH341_PACKET_LENGTH); | 
 | 	ch341->tx_buf[0] = CH341A_CMD_UIO_STREAM; | 
 | 	ch341->tx_buf[1] = CH341A_CMD_UIO_STM_OUT | 0x37; | 
 | 	ch341->tx_buf[2] = CH341A_CMD_UIO_STM_DIR | (enable ? 0x3f : 0x00); | 
 | 	ch341->tx_buf[3] = CH341A_CMD_UIO_STM_END; | 
 |  | 
 | 	return usb_bulk_msg(ch341->udev, ch341->write_pipe, ch341->tx_buf, 4, | 
 | 			    NULL, CH341_DEFAULT_TIMEOUT); | 
 | } | 
 |  | 
 | static struct spi_board_info chip = { | 
 | 	.modalias = "spi-ch341a", | 
 | }; | 
 |  | 
 | static int ch341_probe(struct usb_interface *intf, | 
 | 		       const struct usb_device_id *id) | 
 | { | 
 | 	struct usb_device *udev = interface_to_usbdev(intf); | 
 | 	struct usb_endpoint_descriptor *in, *out; | 
 | 	struct ch341_spi_dev *ch341; | 
 | 	struct spi_controller *ctrl; | 
 | 	int ret; | 
 |  | 
 | 	ret = usb_find_common_endpoints(intf->cur_altsetting, &in, &out, NULL, | 
 | 					NULL); | 
 | 	if (ret) | 
 | 		return ret; | 
 |  | 
 | 	ctrl = devm_spi_alloc_host(&udev->dev, sizeof(struct ch341_spi_dev)); | 
 | 	if (!ctrl) | 
 | 		return -ENOMEM; | 
 |  | 
 | 	ch341 = spi_controller_get_devdata(ctrl); | 
 | 	ch341->ctrl = ctrl; | 
 | 	ch341->udev = udev; | 
 | 	ch341->write_pipe = usb_sndbulkpipe(udev, usb_endpoint_num(out)); | 
 | 	ch341->read_pipe = usb_rcvbulkpipe(udev, usb_endpoint_num(in)); | 
 |  | 
 | 	ch341->rx_len = usb_endpoint_maxp(in); | 
 | 	ch341->rx_buf = devm_kzalloc(&udev->dev, ch341->rx_len, GFP_KERNEL); | 
 | 	if (!ch341->rx_buf) | 
 | 		return -ENOMEM; | 
 |  | 
 | 	ch341->rx_urb = usb_alloc_urb(0, GFP_KERNEL); | 
 | 	if (!ch341->rx_urb) | 
 | 		return -ENOMEM; | 
 |  | 
 | 	ch341->tx_buf = | 
 | 		devm_kzalloc(&udev->dev, CH341_PACKET_LENGTH, GFP_KERNEL); | 
 | 	if (!ch341->tx_buf) | 
 | 		return -ENOMEM; | 
 |  | 
 | 	usb_fill_bulk_urb(ch341->rx_urb, udev, ch341->read_pipe, ch341->rx_buf, | 
 | 			  ch341->rx_len, ch341_recv, ch341); | 
 |  | 
 | 	ret = usb_submit_urb(ch341->rx_urb, GFP_KERNEL); | 
 | 	if (ret) { | 
 | 		usb_free_urb(ch341->rx_urb); | 
 | 		return -ENOMEM; | 
 | 	} | 
 |  | 
 | 	ctrl->bus_num = -1; | 
 | 	ctrl->mode_bits = SPI_CPHA; | 
 | 	ctrl->transfer_one = ch341_transfer_one; | 
 | 	ctrl->set_cs = ch341_set_cs; | 
 | 	ctrl->auto_runtime_pm = false; | 
 |  | 
 | 	usb_set_intfdata(intf, ch341); | 
 |  | 
 | 	ret = ch341_config_stream(ch341); | 
 | 	if (ret) | 
 | 		return ret; | 
 |  | 
 | 	ret = ch341_enable_pins(ch341, true); | 
 | 	if (ret) | 
 | 		return ret; | 
 |  | 
 | 	ret = spi_register_controller(ctrl); | 
 | 	if (ret) | 
 | 		return ret; | 
 |  | 
 | 	ch341->spidev = spi_new_device(ctrl, &chip); | 
 | 	if (!ch341->spidev) | 
 | 		return -ENOMEM; | 
 |  | 
 | 	return 0; | 
 | } | 
 |  | 
 | static void ch341_disconnect(struct usb_interface *intf) | 
 | { | 
 | 	struct ch341_spi_dev *ch341 = usb_get_intfdata(intf); | 
 |  | 
 | 	spi_unregister_device(ch341->spidev); | 
 | 	spi_unregister_controller(ch341->ctrl); | 
 | 	ch341_enable_pins(ch341, false); | 
 | 	usb_free_urb(ch341->rx_urb); | 
 | } | 
 |  | 
 | static const struct usb_device_id ch341_id_table[] = { | 
 | 	{ USB_DEVICE(0x1a86, 0x5512) }, | 
 | 	{ } | 
 | }; | 
 | MODULE_DEVICE_TABLE(usb, ch341_id_table); | 
 |  | 
 | static struct usb_driver ch341a_usb_driver = { | 
 | 	.name = "spi-ch341", | 
 | 	.probe = ch341_probe, | 
 | 	.disconnect = ch341_disconnect, | 
 | 	.id_table = ch341_id_table, | 
 | }; | 
 | module_usb_driver(ch341a_usb_driver); | 
 |  | 
 | MODULE_AUTHOR("Johannes Thumshirn <jth@kernel.org>"); | 
 | MODULE_DESCRIPTION("QiHeng Electronics ch341 USB2SPI"); | 
 | MODULE_LICENSE("GPL v2"); |