| // SPDX-License-Identifier: GPL-2.0-or-later |
| /* |
| * Copyright 2013 Eukréa Electromatique <eric@eukrea.com> |
| * Copyright 2013 Eukréa Electromatique <denis@eukrea.com> |
| */ |
| |
| /* |
| * Module contains : i.MX282 + 64MB DDR2 + NAND + Ethernet PHY + RTC |
| */ |
| |
| /dts-v1/; |
| #include "imx28-eukrea-mbmx28lc.dtsi" |
| |
| / { |
| model = "Eukrea Electromatique MBMX283LC"; |
| compatible = "eukrea,mbmx283lc", "eukrea,mbmx28lc", "fsl,imx28"; |
| |
| memory@40000000 { |
| device_type = "memory"; |
| reg = <0x40000000 0x04000000>; |
| }; |
| }; |
| |
| &gpmi { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&gpmi_pins_a>; |
| status = "okay"; |
| }; |
| |
| &i2c0 { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&i2c0_pins_a>; |
| status = "okay"; |
| |
| pcf8563: rtc@51 { |
| compatible = "nxp,pcf8563"; |
| reg = <0x51>; |
| }; |
| }; |
| |
| |
| &mac0 { |
| phy-mode = "rmii"; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&mac0_pins_a>; |
| phy-reset-gpios = <&gpio4 13 GPIO_ACTIVE_LOW>; |
| status = "okay"; |
| }; |
| |
| &pinctrl{ |
| pinctrl-names = "default"; |
| pinctrl-0 = <&hog_pins_cpuimx283>; |
| |
| hog_pins_cpuimx283: hog-cpuimx283@0 { |
| reg = <0>; |
| fsl,pinmux-ids = < |
| MX28_PAD_ENET0_RX_CLK__GPIO_4_13 |
| MX28_PAD_ENET0_TX_CLK__GPIO_4_5 |
| >; |
| fsl,drive-strength = <MXS_DRIVE_4mA>; |
| fsl,voltage = <MXS_VOLTAGE_HIGH>; |
| fsl,pull-up = <MXS_PULL_ENABLE>; |
| }; |
| }; |
