blob: 72b020deb46b9352a5365410b2011e55b4c56021 [file] [log] [blame]
#ifndef _ASM_X86_PGTABLE_32_H
#define _ASM_X86_PGTABLE_32_H
/*
* The Linux memory management assumes a three-level page table setup. On
* the i386, we use that, but "fold" the mid level into the top-level page
* table, so that we physically have the same two-level page table as the
* i386 mmu expects.
*
* This file contains the functions and defines necessary to modify and use
* the i386 page table tree.
*/
#ifndef __ASSEMBLY__
#include <asm/processor.h>
#include <asm/fixmap.h>
#include <linux/threads.h>
#include <asm/paravirt.h>
#include <linux/bitops.h>
#include <linux/slab.h>
#include <linux/list.h>
#include <linux/spinlock.h>
struct mm_struct;
struct vm_area_struct;
extern pgd_t swapper_pg_dir[1024];
static inline void pgtable_cache_init(void) { }
static inline void check_pgt_cache(void) { }
void paging_init(void);
extern void set_pmd_pfn(unsigned long, unsigned long, pgprot_t);
/*
* The Linux x86 paging architecture is 'compile-time dual-mode', it
* implements both the traditional 2-level x86 page tables and the
* newer 3-level PAE-mode page tables.
*/
#ifdef CONFIG_X86_PAE
# include <asm/pgtable-3level-defs.h>
# define PMD_SIZE (1UL << PMD_SHIFT)
# define PMD_MASK (~(PMD_SIZE - 1))
#else
# include <asm/pgtable-2level-defs.h>
#endif
#define PGDIR_SIZE (1UL << PGDIR_SHIFT)
#define PGDIR_MASK (~(PGDIR_SIZE - 1))
/* Just any arbitrary offset to the start of the vmalloc VM area: the
* current 8MB value just means that there will be a 8MB "hole" after the
* physical memory until the kernel virtual memory starts. That means that
* any out-of-bounds memory accesses will hopefully be caught.
* The vmalloc() routines leaves a hole of 4kB between each vmalloced
* area for the same reason. ;)
*/
#define VMALLOC_OFFSET (8 * 1024 * 1024)
#define VMALLOC_START ((unsigned long)high_memory + VMALLOC_OFFSET)
#ifdef CONFIG_X86_PAE
#define LAST_PKMAP 512
#else
#define LAST_PKMAP 1024
#endif
#define PKMAP_BASE ((FIXADDR_BOOT_START - PAGE_SIZE * (LAST_PKMAP + 1)) \
& PMD_MASK)
#ifdef CONFIG_HIGHMEM
# define VMALLOC_END (PKMAP_BASE - 2 * PAGE_SIZE)
#else
# define VMALLOC_END (FIXADDR_START - 2 * PAGE_SIZE)
#endif
#define MAXMEM (VMALLOC_END - PAGE_OFFSET - __VMALLOC_RESERVE)
/*
* Define this if things work differently on an i386 and an i486:
* it will (on an i486) warn about kernel memory accesses that are
* done without a 'access_ok(VERIFY_WRITE,..)'
*/
#undef TEST_ACCESS_OK
/* The boot page tables (all created as a single array) */
extern unsigned long pg0[];
#define pte_present(x) ((x).pte_low & (_PAGE_PRESENT | _PAGE_PROTNONE))
/* To avoid harmful races, pmd_none(x) should check only the lower when PAE */
#define pmd_none(x) (!(unsigned long)pmd_val((x)))
#define pmd_present(x) (pmd_val((x)) & _PAGE_PRESENT)
#define pmd_bad(x) ((pmd_val(x) & (PTE_FLAGS_MASK & ~_PAGE_USER)) != _KERNPG_TABLE)
#define pages_to_mb(x) ((x) >> (20-PAGE_SHIFT))
#ifdef CONFIG_X86_PAE
# include <asm/pgtable-3level.h>
#else
# include <asm/pgtable-2level.h>
#endif
/*
* Conversion functions: convert a page and protection to a page entry,
* and a page entry and page directory to the page they refer to.
*/
#define mk_pte(page, pgprot) pfn_pte(page_to_pfn(page), (pgprot))
static inline int pud_large(pud_t pud) { return 0; }
/*
* the pmd page can be thought of an array like this: pmd_t[PTRS_PER_PMD]
*
* this macro returns the index of the entry in the pmd page which would
* control the given virtual address
*/
#define pmd_index(address) \
(((address) >> PMD_SHIFT) & (PTRS_PER_PMD - 1))
/*
* the pte page can be thought of an array like this: pte_t[PTRS_PER_PTE]
*
* this macro returns the index of the entry in the pte page which would
* control the given virtual address
*/
#define pte_index(address) \
(((address) >> PAGE_SHIFT) & (PTRS_PER_PTE - 1))
#define pte_offset_kernel(dir, address) \
((pte_t *)pmd_page_vaddr(*(dir)) + pte_index((address)))
#define pmd_page(pmd) (pfn_to_page(pmd_val((pmd)) >> PAGE_SHIFT))
#define pmd_page_vaddr(pmd) \
((unsigned long)__va(pmd_val((pmd)) & PTE_PFN_MASK))
#if defined(CONFIG_HIGHPTE)
#define pte_offset_map(dir, address) \
((pte_t *)kmap_atomic_pte(pmd_page(*(dir)), KM_PTE0) + \
pte_index((address)))
#define pte_offset_map_nested(dir, address) \
((pte_t *)kmap_atomic_pte(pmd_page(*(dir)), KM_PTE1) + \
pte_index((address)))
#define pte_unmap(pte) kunmap_atomic((pte), KM_PTE0)
#define pte_unmap_nested(pte) kunmap_atomic((pte), KM_PTE1)
#else
#define pte_offset_map(dir, address) \
((pte_t *)page_address(pmd_page(*(dir))) + pte_index((address)))
#define pte_offset_map_nested(dir, address) pte_offset_map((dir), (address))
#define pte_unmap(pte) do { } while (0)
#define pte_unmap_nested(pte) do { } while (0)
#endif
/* Clear a kernel PTE and flush it from the TLB */
#define kpte_clear_flush(ptep, vaddr) \
do { \
pte_clear(&init_mm, (vaddr), (ptep)); \
__flush_tlb_one((vaddr)); \
} while (0)
/*
* The i386 doesn't have any external MMU info: the kernel page
* tables contain all the necessary information.
*/
#define update_mmu_cache(vma, address, pte) do { } while (0)
#endif /* !__ASSEMBLY__ */
/*
* kern_addr_valid() is (1) for FLATMEM and (0) for
* SPARSEMEM and DISCONTIGMEM
*/
#ifdef CONFIG_FLATMEM
#define kern_addr_valid(addr) (1)
#else
#define kern_addr_valid(kaddr) (0)
#endif
#define io_remap_pfn_range(vma, vaddr, pfn, size, prot) \
remap_pfn_range(vma, vaddr, pfn, size, prot)
#endif /* _ASM_X86_PGTABLE_32_H */