| /* SPDX-License-Identifier: GPL-2.0-only */ |
| /* |
| * This file is part of wl12xx |
| * |
| * Copyright (C) 2011 Texas Instruments Inc. |
| */ |
| |
| #ifndef __WL12XX_CONF_H__ |
| #define __WL12XX_CONF_H__ |
| |
| /* these are number of channels on the band divided by two, rounded up */ |
| #define CONF_TX_PWR_COMPENSATION_LEN_2 7 |
| #define CONF_TX_PWR_COMPENSATION_LEN_5 18 |
| |
| struct wl12xx_conf_rf { |
| /* |
| * Per channel power compensation for 2.4GHz |
| * |
| * Range: s8 |
| */ |
| u8 tx_per_channel_power_compensation_2[CONF_TX_PWR_COMPENSATION_LEN_2]; |
| |
| /* |
| * Per channel power compensation for 5GHz |
| * |
| * Range: s8 |
| */ |
| u8 tx_per_channel_power_compensation_5[CONF_TX_PWR_COMPENSATION_LEN_5]; |
| }; |
| |
| struct wl12xx_priv_conf { |
| struct wl12xx_conf_rf rf; |
| struct conf_memory_settings mem_wl127x; |
| }; |
| |
| enum wl12xx_sg_params { |
| /* |
| * Configure the min and max time BT gains the antenna |
| * in WLAN / BT master basic rate |
| * |
| * Range: 0 - 255 (ms) |
| */ |
| WL12XX_CONF_SG_ACL_BT_MASTER_MIN_BR = 0, |
| WL12XX_CONF_SG_ACL_BT_MASTER_MAX_BR, |
| |
| /* |
| * Configure the min and max time BT gains the antenna |
| * in WLAN / BT slave basic rate |
| * |
| * Range: 0 - 255 (ms) |
| */ |
| WL12XX_CONF_SG_ACL_BT_SLAVE_MIN_BR, |
| WL12XX_CONF_SG_ACL_BT_SLAVE_MAX_BR, |
| |
| /* |
| * Configure the min and max time BT gains the antenna |
| * in WLAN / BT master EDR |
| * |
| * Range: 0 - 255 (ms) |
| */ |
| WL12XX_CONF_SG_ACL_BT_MASTER_MIN_EDR, |
| WL12XX_CONF_SG_ACL_BT_MASTER_MAX_EDR, |
| |
| /* |
| * Configure the min and max time BT gains the antenna |
| * in WLAN / BT slave EDR |
| * |
| * Range: 0 - 255 (ms) |
| */ |
| WL12XX_CONF_SG_ACL_BT_SLAVE_MIN_EDR, |
| WL12XX_CONF_SG_ACL_BT_SLAVE_MAX_EDR, |
| |
| /* |
| * The maximum time WLAN can gain the antenna |
| * in WLAN PSM / BT master/slave BR |
| * |
| * Range: 0 - 255 (ms) |
| */ |
| WL12XX_CONF_SG_ACL_WLAN_PS_MASTER_BR, |
| WL12XX_CONF_SG_ACL_WLAN_PS_SLAVE_BR, |
| |
| /* |
| * The maximum time WLAN can gain the antenna |
| * in WLAN PSM / BT master/slave EDR |
| * |
| * Range: 0 - 255 (ms) |
| */ |
| WL12XX_CONF_SG_ACL_WLAN_PS_MASTER_EDR, |
| WL12XX_CONF_SG_ACL_WLAN_PS_SLAVE_EDR, |
| |
| /* TODO: explain these values */ |
| WL12XX_CONF_SG_ACL_WLAN_ACTIVE_MASTER_MIN_BR, |
| WL12XX_CONF_SG_ACL_WLAN_ACTIVE_MASTER_MAX_BR, |
| WL12XX_CONF_SG_ACL_WLAN_ACTIVE_SLAVE_MIN_BR, |
| WL12XX_CONF_SG_ACL_WLAN_ACTIVE_SLAVE_MAX_BR, |
| WL12XX_CONF_SG_ACL_WLAN_ACTIVE_MASTER_MIN_EDR, |
| WL12XX_CONF_SG_ACL_WLAN_ACTIVE_MASTER_MAX_EDR, |
| WL12XX_CONF_SG_ACL_WLAN_ACTIVE_SLAVE_MIN_EDR, |
| WL12XX_CONF_SG_ACL_WLAN_ACTIVE_SLAVE_MAX_EDR, |
| |
| WL12XX_CONF_SG_ACL_ACTIVE_SCAN_WLAN_BR, |
| WL12XX_CONF_SG_ACL_ACTIVE_SCAN_WLAN_EDR, |
| WL12XX_CONF_SG_ACL_PASSIVE_SCAN_BT_BR, |
| WL12XX_CONF_SG_ACL_PASSIVE_SCAN_WLAN_BR, |
| WL12XX_CONF_SG_ACL_PASSIVE_SCAN_BT_EDR, |
| WL12XX_CONF_SG_ACL_PASSIVE_SCAN_WLAN_EDR, |
| |
| /* |
| * Compensation percentage of probe requests when scan initiated |
| * during BT voice/ACL link. |
| * |
| * Range: 0 - 255 (%) |
| */ |
| WL12XX_CONF_SG_AUTO_SCAN_PROBE_REQ, |
| |
| /* |
| * Compensation percentage of probe requests when active scan initiated |
| * during BT voice |
| * |
| * Range: 0 - 255 (%) |
| */ |
| WL12XX_CONF_SG_ACTIVE_SCAN_DURATION_FACTOR_HV3, |
| |
| /* |
| * Compensation percentage of WLAN active scan window if initiated |
| * during BT A2DP |
| * |
| * Range: 0 - 1000 (%) |
| */ |
| WL12XX_CONF_SG_ACTIVE_SCAN_DURATION_FACTOR_A2DP, |
| |
| /* |
| * Compensation percentage of WLAN passive scan window if initiated |
| * during BT A2DP BR |
| * |
| * Range: 0 - 1000 (%) |
| */ |
| WL12XX_CONF_SG_PASSIVE_SCAN_DUR_FACTOR_A2DP_BR, |
| |
| /* |
| * Compensation percentage of WLAN passive scan window if initiated |
| * during BT A2DP EDR |
| * |
| * Range: 0 - 1000 (%) |
| */ |
| WL12XX_CONF_SG_PASSIVE_SCAN_DUR_FACTOR_A2DP_EDR, |
| |
| /* |
| * Compensation percentage of WLAN passive scan window if initiated |
| * during BT voice |
| * |
| * Range: 0 - 1000 (%) |
| */ |
| WL12XX_CONF_SG_PASSIVE_SCAN_DUR_FACTOR_HV3, |
| |
| /* TODO: explain these values */ |
| WL12XX_CONF_SG_CONSECUTIVE_HV3_IN_PASSIVE_SCAN, |
| WL12XX_CONF_SG_BCN_HV3_COLL_THR_IN_PASSIVE_SCAN, |
| WL12XX_CONF_SG_TX_RX_PROTECT_BW_IN_PASSIVE_SCAN, |
| |
| /* |
| * Defines whether the SG will force WLAN host to enter/exit PSM |
| * |
| * Range: 1 - SG can force, 0 - host handles PSM |
| */ |
| WL12XX_CONF_SG_STA_FORCE_PS_IN_BT_SCO, |
| |
| /* |
| * Defines antenna configuration (single/dual antenna) |
| * |
| * Range: 0 - single antenna, 1 - dual antenna |
| */ |
| WL12XX_CONF_SG_ANTENNA_CONFIGURATION, |
| |
| /* |
| * The threshold (percent) of max consecutive beacon misses before |
| * increasing priority of beacon reception. |
| * |
| * Range: 0 - 100 (%) |
| */ |
| WL12XX_CONF_SG_BEACON_MISS_PERCENT, |
| |
| /* |
| * Protection time of the DHCP procedure. |
| * |
| * Range: 0 - 100000 (ms) |
| */ |
| WL12XX_CONF_SG_DHCP_TIME, |
| |
| /* |
| * RX guard time before the beginning of a new BT voice frame during |
| * which no new WLAN trigger frame is transmitted. |
| * |
| * Range: 0 - 100000 (us) |
| */ |
| WL12XX_CONF_SG_RXT, |
| |
| /* |
| * TX guard time before the beginning of a new BT voice frame during |
| * which no new WLAN frame is transmitted. |
| * |
| * Range: 0 - 100000 (us) |
| */ |
| WL12XX_CONF_SG_TXT, |
| |
| /* |
| * Enable adaptive RXT/TXT algorithm. If disabled, the host values |
| * will be utilized. |
| * |
| * Range: 0 - disable, 1 - enable |
| */ |
| WL12XX_CONF_SG_ADAPTIVE_RXT_TXT, |
| |
| /* TODO: explain this value */ |
| WL12XX_CONF_SG_GENERAL_USAGE_BIT_MAP, |
| |
| /* |
| * Number of consecutive BT voice frames not interrupted by WLAN |
| * |
| * Range: 0 - 100 |
| */ |
| WL12XX_CONF_SG_HV3_MAX_SERVED, |
| |
| /* |
| * The used WLAN legacy service period during active BT ACL link |
| * |
| * Range: 0 - 255 (ms) |
| */ |
| WL12XX_CONF_SG_PS_POLL_TIMEOUT, |
| |
| /* |
| * The used WLAN UPSD service period during active BT ACL link |
| * |
| * Range: 0 - 255 (ms) |
| */ |
| WL12XX_CONF_SG_UPSD_TIMEOUT, |
| |
| WL12XX_CONF_SG_CONSECUTIVE_CTS_THRESHOLD, |
| WL12XX_CONF_SG_STA_RX_WINDOW_AFTER_DTIM, |
| WL12XX_CONF_SG_STA_CONNECTION_PROTECTION_TIME, |
| |
| /* AP params */ |
| WL12XX_CONF_AP_BEACON_MISS_TX, |
| WL12XX_CONF_AP_RX_WINDOW_AFTER_BEACON, |
| WL12XX_CONF_AP_BEACON_WINDOW_INTERVAL, |
| WL12XX_CONF_AP_CONNECTION_PROTECTION_TIME, |
| WL12XX_CONF_AP_BT_ACL_VAL_BT_SERVE_TIME, |
| WL12XX_CONF_AP_BT_ACL_VAL_WL_SERVE_TIME, |
| |
| /* CTS Diluting params */ |
| WL12XX_CONF_SG_CTS_DILUTED_BAD_RX_PACKETS_TH, |
| WL12XX_CONF_SG_CTS_CHOP_IN_DUAL_ANT_SCO_MASTER, |
| |
| WL12XX_CONF_SG_TEMP_PARAM_1, |
| WL12XX_CONF_SG_TEMP_PARAM_2, |
| WL12XX_CONF_SG_TEMP_PARAM_3, |
| WL12XX_CONF_SG_TEMP_PARAM_4, |
| WL12XX_CONF_SG_TEMP_PARAM_5, |
| WL12XX_CONF_SG_TEMP_PARAM_6, |
| WL12XX_CONF_SG_TEMP_PARAM_7, |
| WL12XX_CONF_SG_TEMP_PARAM_8, |
| WL12XX_CONF_SG_TEMP_PARAM_9, |
| WL12XX_CONF_SG_TEMP_PARAM_10, |
| |
| WL12XX_CONF_SG_PARAMS_MAX, |
| WL12XX_CONF_SG_PARAMS_ALL = 0xff |
| }; |
| |
| #endif /* __WL12XX_CONF_H__ */ |
