blob: a8621459005bfd7a381595b8333f9ae58449a6f4 [file] [log] [blame]
# SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
%YAML 1.2
---
$id: http://devicetree.org/schemas/display/panel/jdi,lpm102a188a.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#
title: JDI LPM102A188A 2560x1800 10.2" DSI Panel
maintainers:
- Diogo Ivo <diogo.ivo@tecnico.ulisboa.pt>
description: |
This panel requires a dual-channel DSI host to operate. It supports two modes:
- left-right: each channel drives the left or right half of the screen
- even-odd: each channel drives the even or odd lines of the screen
Each of the DSI channels controls a separate DSI peripheral. The peripheral
driven by the first link (DSI-LINK1) is considered the primary peripheral
and controls the device. The 'link2' property contains a phandle to the
peripheral driven by the second link (DSI-LINK2).
allOf:
- $ref: panel-common.yaml#
properties:
compatible:
const: jdi,lpm102a188a
reg:
maxItems: 1
enable-gpios: true
reset-gpios: true
power-supply: true
backlight: true
ddi-supply:
description: The regulator that provides IOVCC (1.8V).
link2:
$ref: /schemas/types.yaml#/definitions/phandle
description: |
phandle to the DSI peripheral on the secondary link. Note that the
presence of this property marks the containing node as DSI-LINK1.
required:
- compatible
- reg
if:
required:
- link2
then:
required:
- power-supply
- ddi-supply
- enable-gpios
- reset-gpios
additionalProperties: false
examples:
- |
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/gpio/tegra-gpio.h>
dsia: dsi@54300000 {
#address-cells = <1>;
#size-cells = <0>;
reg = <0x0 0x54300000 0x0 0x00040000>;
link2: panel@0 {
compatible = "jdi,lpm102a188a";
reg = <0>;
};
};
dsib: dsi@54400000{
#address-cells = <1>;
#size-cells = <0>;
reg = <0x0 0x54400000 0x0 0x00040000>;
nvidia,ganged-mode = <&dsia>;
link1: panel@0 {
compatible = "jdi,lpm102a188a";
reg = <0>;
power-supply = <&pplcd_vdd>;
ddi-supply = <&pp1800_lcdio>;
enable-gpios = <&gpio TEGRA_GPIO(V, 1) GPIO_ACTIVE_HIGH>;
reset-gpios = <&gpio TEGRA_GPIO(V, 2) GPIO_ACTIVE_LOW>;
link2 = <&link2>;
backlight = <&backlight>;
};
};
...