blob: f096f286da19cd1db7a92294a531e976e57b0bdb [file] [log] [blame]
# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/gpio/brcm,brcmstb-gpio.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#
title: Broadcom STB "UPG GIO" GPIO controller
description: >
The controller's registers are organized as sets of eight 32-bit
registers with each set controlling a bank of up to 32 pins. A single
interrupt is shared for all of the banks handled by the controller.
maintainers:
- Doug Berger <opendmb@gmail.com>
- Florian Fainelli <f.fainelli@gmail.com>
properties:
compatible:
items:
- enum:
- brcm,bcm7445-gpio
- const: brcm,brcmstb-gpio
reg:
maxItems: 1
description: >
Define the base and range of the I/O address space containing
the brcmstb GPIO controller registers
"#gpio-cells":
const: 2
description: >
The first cell is the pin number (within the controller's
pin space), and the second is used for the following:
bit[0]: polarity (0 for active-high, 1 for active-low)
gpio-controller: true
brcm,gpio-bank-widths:
$ref: /schemas/types.yaml#/definitions/uint32-array
description: >
Number of GPIO lines for each bank. Number of elements must
correspond to number of banks suggested by the 'reg' property.
interrupts:
maxItems: 1
description: >
The interrupt shared by all GPIO lines for this controller.
"#interrupt-cells":
const: 2
description: |
The first cell is the GPIO number, the second should specify
flags. The following subset of flags is supported:
- bits[3:0] trigger type and level flags
1 = low-to-high edge triggered
2 = high-to-low edge triggered
4 = active high level-sensitive
8 = active low level-sensitive
Valid combinations are 1, 2, 3, 4, 8.
interrupt-controller: true
gpio-ranges: true
wakeup-source:
type: boolean
description: >
GPIOs for this controller can be used as a wakeup source
required:
- compatible
- reg
- gpio-controller
- "#gpio-cells"
- brcm,gpio-bank-widths
additionalProperties: false
examples:
- |
upg_gio: gpio@f040a700 {
#gpio-cells = <2>;
#interrupt-cells = <2>;
compatible = "brcm,bcm7445-gpio", "brcm,brcmstb-gpio";
gpio-controller;
interrupt-controller;
reg = <0xf040a700 0x80>;
interrupt-parent = <&irq0_intc>;
interrupts = <0x6>;
brcm,gpio-bank-widths = <32 32 32 24>;
gpio-ranges = <&pinctrl 0 0 120>;
};
upg_gio_aon: gpio@f04172c0 {
#gpio-cells = <2>;
#interrupt-cells = <2>;
compatible = "brcm,bcm7445-gpio", "brcm,brcmstb-gpio";
gpio-controller;
interrupt-controller;
reg = <0xf04172c0 0x40>;
interrupt-parent = <&irq0_aon_intc>;
interrupts = <0x6>;
wakeup-source;
brcm,gpio-bank-widths = <18 4>;
};